Hi have a look at this post

http://igmaynard.co.uk/bongo/forum/view ... +fuel+pump

Hi I had exactly the same issue with mine I cured it by taking the needle off and re-fitting it in a slightly different position what I found on mine is when you turn the ignition on the needle will move up slightly I set the needle to line up with the small line just past the 0 MPH mark when the ig...

Thanks Rita that info was what I needed will try it later when/if my new pump arrives today.

I know its in the manual I'm just to tight to pay the £60 - £70 for it especially as this is the only info I need....

Cheers

Hi All, Does anyone know the fuel injection pump timing setup procedure for the 2.5TD 1995 engine? I have got the dial gauge to go in the pump but cant find anything on which timing marks you go by on the engine is it the crank, camshaft or fuel pump pulleys if you do actually use these? the only in...

Thanks Cookan thats what I needed

Not really its the Bosch part number I was after I know someone who can get discounted Bosch parts but I need the number.

Thanks anyway

Hi all,

Does anyone have the Bosch part number for the 2.5TD Zexel injection pump seal kit?

Thanks

Hi,

I had the same problem lubricated the universal joint and it was ok for a few weeks then it started to stiffen up again so I bought a new joint when I took the old one off it was shot very stiff in one direction and a fair bit of wear steering feels brand new now

Hi All, I put a new clock in today being looking for ages for one that would fit in the headlining I had to get it from New Zealand £21.50 including postage it seems to be of reasonably good quality build compare to some of the cheap stuff on ebay. The photos make the display look a bit funny but it...

Hi, Bit of a late reply so you may of already sorted this! there are small bulbs fitted in the back of the control panel 3x in total one for the fan switch, one for the vent position and one for the temperature setting they are a standard R284 type the ones fitted in mine were 1.2 watts but a I fitt...

Hi, I had exactly the same problem one of the cold start solenoids had gone open circuit got a replacement made a slight improvement but still spluttering especially in the colder weather ended up checking the banjo filter in the fuel pump and found it was probably 50% blocked up cleaned it out and ...

Got round to looking into this today the oil was running down from above the oil filter but below the cylinder head directly behind the turbo couldn't really see much tried an inspection mirror all I could see was a pool of oil on the top of the engine oil cooler was concerned it was coming from the...

I have a small oil leak from around the oil filter area first of all I thought it was the oil filter so I replaced the filter with a better quaility blueprint one but it still leaks I checked the filter sealing surface was good no damage so it must be coming from somewhere else its not coming down f...

Thought I would update this

The new cylinder head gasket had a bead of silicone on it in the same area as shown in the manual so I went with that and touch wood 2500 miles later engine still running with no problems touch wood.....