Technical questions and answers about the Mazda Bongo
Moderators: Doone, westonwarrior
-
ELZE
- Supreme Being
- Posts: 1305
- Joined: Sat Feb 04, 2012 9:31 pm
- Location: Whitley Bay
Post
by ELZE » Wed Nov 06, 2013 8:35 pm
g8dhe wrote:There have been previous threads where rear wipers have been removed due to problems with the support/bearing. The problem is if its fitted but NOT working then its an MOT failure, if its not present then it can't be tested and thus can't be failed .... idiotic to my mind but there we go ....

passed MOT recently no issues but If as you say I remove the knob and fit one it would have to work. I am only really trying to confirm that all bongos' had one as standard and if so I will have a go reinstating it. If all fails I can just screw the knob back on.
A Bongo is for life, not just for Christmas
-
ELZE
- Supreme Being
- Posts: 1305
- Joined: Sat Feb 04, 2012 9:31 pm
- Location: Whitley Bay
Post
by ELZE » Wed Nov 06, 2013 8:36 pm
Gasy wrote:Rear wash / wipe fuse is number 13 next to drivers right knee
Thanks for this!
A Bongo is for life, not just for Christmas
-
ELZE
- Supreme Being
- Posts: 1305
- Joined: Sat Feb 04, 2012 9:31 pm
- Location: Whitley Bay
Post
by ELZE » Fri Nov 08, 2013 12:25 pm
A Bongo is for life, not just for Christmas
-
wonkanoby
- Supreme Being
- Posts: 1729
- Joined: Thu Nov 10, 2005 12:00 pm
- Location: sunny catford
Post
by wonkanoby » Fri Nov 08, 2013 2:47 pm
usual reason with washer is broken wire were wire passes from body to the door
much the same as on front doors
-
haybal
- Bongolier
- Posts: 155
- Joined: Fri May 24, 2013 8:40 am
- Location: Essex
Post
by haybal » Fri Nov 08, 2013 3:03 pm
Fuse 13 does indeed do rear wiper & washer, according to the fact sheet. hope you get it sorted.
-
ELZE
- Supreme Being
- Posts: 1305
- Joined: Sat Feb 04, 2012 9:31 pm
- Location: Whitley Bay
Post
by ELZE » Fri Nov 08, 2013 4:16 pm
So isit a door skin removal and investigation with a voltage meter?
A Bongo is for life, not just for Christmas
-
wonkanoby
- Supreme Being
- Posts: 1729
- Joined: Thu Nov 10, 2005 12:00 pm
- Location: sunny catford
Post
by wonkanoby » Sat Nov 09, 2013 9:32 am
loom usually bust top right of tail gate were loom enters
-
hwyaden
- Bongolier
- Posts: 133
- Joined: Wed Sep 25, 2013 10:06 pm
Post
by hwyaden » Sun Nov 17, 2013 2:16 pm
i'm still without a rear wiper. can i just buy a new spring to fit on it and if so where would i get one? do i just measure the spring on there and order one off ebay? or is it something more special.

-
hwyaden
- Bongolier
- Posts: 133
- Joined: Wed Sep 25, 2013 10:06 pm
Post
by hwyaden » Sun Nov 17, 2013 2:17 pm
also rear washer isn't working - what should i look for?
-
Simon Jones
- Supreme Being
- Posts: 9341
- Joined: Mon Aug 29, 2005 3:34 pm
- Location: Salisbury (ish), Wiltshire
Post
by Simon Jones » Sun Nov 17, 2013 2:26 pm
If you can't get the wiper arm to pivot properly due to repainting, you're probably best off getting a second hand one from a breaker. As mentioned on another thread today, the washer pumps do tend to fail after a while. You can sometimes repair them, but it's probably better to get a replacement on ebay for under £10, but you will have to tweak the configuration of the contacts as they are different to the standard pump.
-
hwyaden
- Bongolier
- Posts: 133
- Joined: Wed Sep 25, 2013 10:06 pm
Post
by hwyaden » Sun Nov 17, 2013 2:27 pm
thankyou

-
ELZE
- Supreme Being
- Posts: 1305
- Joined: Sat Feb 04, 2012 9:31 pm
- Location: Whitley Bay
Post
by ELZE » Fri Dec 13, 2013 4:50 pm
ELZE wrote:Well this one is with the cap fitted
I was posting the other picture with the cap removed then photbucket went into a dive and logged me out?
So is reinstatement possible ot just a waste of time and energy? I would not even be discussing this if it were not for my rear R sole camera getting obstructed in heavy weather
Remember this guys?
Well the washers was working but could not understand why the wiper motor was not functioning because as confirmed on here it all works off the same ciruit/fuse?? Well took the rear panel off last week and blasted everything with WD and guess what, it has started working this morning. I only tried it today and presto! Now I have a nice stainless steel wiper blade to fit but I need the wiper arm and nut? Anyone know where I can purchase these or maybe a scrapper?
I would be so chuffed at having a rear wiper. My last Bongo had one obviously and I have missed it so much with all the wet and spray on the roads this winter time.
A Bongo is for life, not just for Christmas