Rear Heater blowing cold???

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Locked
Coughers
Apprentice Bongonaut
Posts: 10
Joined: Sat Oct 27, 2012 1:59 pm
Location: Birmingham

Rear Heater blowing cold???

Post by Coughers » Mon Jan 21, 2013 9:57 pm

Hello all,

I recently bought a 1996 bongo which the 30A fuse was missing for the rear heater. I have now replaced the fuse and the rear heater is now blowing but it only blows cold air, even when the front is blowing hot. What can I do???

Thank you for your time

Jack
User avatar
Simon Jones
Supreme Being
Posts: 9341
Joined: Mon Aug 29, 2005 3:34 pm
Location: Salisbury (ish), Wiltshire

Re: Rear Heater blowing cold???

Post by Simon Jones » Mon Jan 21, 2013 10:51 pm

What type of controls have you got at the front: digital or manual? The rear controls are slightly different but both will need the slider or knob set to the hot setting.
Coughers
Apprentice Bongonaut
Posts: 10
Joined: Sat Oct 27, 2012 1:59 pm
Location: Birmingham

Re: Rear Heater blowing cold???

Post by Coughers » Mon Jan 21, 2013 10:56 pm

Ive got the digital control panel in the front and the manual panel with a sliding knob to set the temp in the back both are set to the highest temp and it still blows cold.
User avatar
Simon Jones
Supreme Being
Posts: 9341
Joined: Mon Aug 29, 2005 3:34 pm
Location: Salisbury (ish), Wiltshire

Re: Rear Heater blowing cold???

Post by Simon Jones » Mon Jan 21, 2013 11:02 pm

In that case, I would guess that a previous owner has bypassed the rear heater perhaps due to a leak in the matrix, or a problem with the steel pipes that run to the rear heater. Have a look under the sill on the drivers side just behind the door and see if there are 2 rubber coolant pipes running up into the van. There should also be two metal pipes for the A/C although these will have a black foam sleeve over them.
Locked

Return to “Techie Stuff”