V6 starting problems

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Locked
User avatar
mantaJim
Bongolier
Posts: 125
Joined: Fri Oct 07, 2011 9:09 pm
Location: Chorley

V6 starting problems

Post by mantaJim » Sun Sep 30, 2012 12:08 pm

I've replaced dizzy, rotor arm, HT leads coil and igniter and my V6 still fails to start.

I do get what appears to be unburnt fuel on my plugs so had assumed fuel delivery wasn't a problem.

The van had cut out a few miles from home after a long journey mainly at motorway speeds. It cut out on the approach to a roundabout and I only noticed when I tried to take off. The van restarted but with a bad misfire and since being transported home fails to start. I've checked the breather under the drivers seat which seems to work but had some gunk in it. It was also very low on fuel when it cut out :oops: and I wonder whether I have crud in the system or an air lock perhaps. When removing the fuel filler cap I don't get the pressure release I used to notice.

Any thoughts - airlock ? If so any advice on how to bleed ?

Having trawled these posts for the past two weeks I realise there are many possible diagnoses.

Cheers Jim
V6 Mushroom
User avatar
Simon Jones
Supreme Being
Posts: 9341
Joined: Mon Aug 29, 2005 3:34 pm
Location: Salisbury (ish), Wiltshire

Re: V6 starting problems

Post by Simon Jones » Sun Sep 30, 2012 3:53 pm

Are you getting a spark on at the plugs? Unscrew a plug, reconnect HT lead and the turn it over on the starter while the plug is earthed to the engine. If spark is ok, then unless the timing is off, that only leaves air and fuel to check. There is a fuel pump in the tank, so it may be worth pulling the carpet up and removing the inspection hatch over the tank. From there you could either stick 12V direct into the pump, or remove the complete unit with the sender. There is a filter on the end of the pickup tube, so it be worth checking / cleaning that.

There is also the crankshaft sensor which has been known to fail. See recent post by Julian AKA 321Away.
User avatar
mantaJim
Bongolier
Posts: 125
Joined: Fri Oct 07, 2011 9:09 pm
Location: Chorley

Re: V6 starting problems

Post by mantaJim » Mon Oct 01, 2012 11:11 pm

Thanks Simon
Yes I get a spark and the plugs look like they are getting fuelled
I'll get the crank sensor looked at

Cheers

Jim
V6 Mushroom
User avatar
mikeonb4c
Supreme Being
Posts: 22877
Joined: Sun Nov 05, 2006 10:49 pm
Location: Living with Mango Bongo in the North West but with a tendency to roam
Contact:

Re: V6 starting problems

Post by mikeonb4c » Mon Oct 01, 2012 11:26 pm

I know I'm always plugging him but Adrian at Japan Direct in Bury 0161-763-3003 is very good with Bongos. You could try calling him. His prices are very good.
User avatar
mantaJim
Bongolier
Posts: 125
Joined: Fri Oct 07, 2011 9:09 pm
Location: Chorley

Re: V6 starting problems

Post by mantaJim » Tue Oct 02, 2012 6:48 pm

Thanks Mike

I have been in touch with Adrian but just waiting for a free slot as he has been really busy and so i've been trying the more simplistic / easier to get to stuff just in case. Hoping to get the van across this week.

Cheers jim
V6 Mushroom
Locked

Return to “Techie Stuff”