Screech when pressing accelerator

[paulandyt]

I have a Freda P Reg 2.5TD 4WD.

When I press the accelerator, a screeching sound comes from the engine area, although it isn't the engine itself. I have been to a garage and they have replaced the inlet gasket manifold, but this didn't fix the problem. They tell me that it sounds like a leaking in the exhaust gasket manifold which is causing the problem and tell me that replacing this gasket should fix the problem.

I just wanted to find out if anyone else has had this problem before before I go back to get that replaced?

Thanks

Paul

[trevd01]

What you describe sounds like the relatively common exhaust manifold stud problem, but you would think that would have easily been spotted if replacing a manifold gasket.

[paulandyt]

Thanks for your response, I will get them to have another look at it and see what they think.

Happy Christmas

Paul

[missfixit70]

I assume they've checked it's not the belts? If they know bongos at all they should know that no 1 manifold stud is a common fault, would have been difficult to miss if they did the gasket.
Whereabouts are you ? you can put your location in by clicking on "user control panel" top right, someone may be able to help out locally with a diagnosis or recommendation of a garage that knows bongos better maybe?

[paulandyt]

Hi, I live in Bristol, any specialists you may know in the area would really help.

Thanks

Paul

[missfixit70]

Doing a search on Bristol and garages brought up this lot - http://www.igmaynard.co.uk/bongo/forum/ ... mit=Search - and there's the list of bongo friendly garages in the members area here - http://www.igmaynard.co.uk/bongo/member ... #databases .I'm sure some of the peeps more local to you will be along shortly, should be about time for Bob to appear
Welcome to the forum by the way

[paulandyt]

Many thanks Kirsty, your help is appreciated! It is good go get support so quickly!

Happy Christmas!

Paul

[missfixit70]

No worries, a search using manifold and stud brings up this lot - http://www.igmaynard.co.uk/bongo/forum/ ... mit=Search - have a wade through it & see if it helps, or try doing a search on squealing and belts, etc, loads of info on here the answers in there somewhere, that's if you haven't got it already. It pays to go into the garage armed with as much knowledge as possible save you a fortune in tooth sucking extras guv

[haydn callow]

You say they replaced the INLET manifold gasket....It is more likely to be the EXAUST manifold or the Ni 1 Exaust manifold stud.

Try ADS Automotive
Unit 200
South Liberty Lane
Bristol
BS3 2TW

0017 9635999


Ask For Adam

[bigdaddycain]

I find it a little strange that the inlet manifold gasket was replaced, i thought they usually made a ticking sound if they were leaking?

[missfixit70]

You say they replaced the INLET manifold gasket....It is more likely to be the EXAUST manifold

missed that bit

[haydn callow]

Well...thats co's you rush to get your reply in before me.

[missfixit70]

As if

[scanner]

A garage that leapt in and changed an inlet manifold gasket because of a screeching noise under acceleration would really worry me.

I hope you've taken it back and asked them to refund the wasted expenditure, as their work didn't cure the fault.

Jeez, you only have to give some twazzocks a shed and a trolley jack and they think they are mechanics

[haydn callow]

Excuse me !!!! I've got a trolly jack and 4 sheds !!!