heater not blowing to leg

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Locked
User avatar
buddyh42
Bongolier
Posts: 185
Joined: Mon Dec 08, 2008 11:52 pm
Location: Livingston,West Lothian

heater not blowing to leg

Post by buddyh42 » Sun Dec 14, 2008 1:09 am

Hi any suggestions on why my heater will only blow air out of dash vents, it wont blow to leg/feet or windscreen?
That'll Be The Day.........


'99 Silver V6 Moonfleet Conversion
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: heater not blowing to leg

Post by missfixit70 » Sun Dec 14, 2008 1:13 am

Loads of threads on this, seems to be a common problem, check the linkages in the drivers footwell, may be broken or just need clipping back in. Did it ever work? Recently had one that the actuator motor was missing. Have you got slider controls or digital climate control?

Image
You can't polish a turd - but you can roll it in glitter.
User avatar
buddyh42
Bongolier
Posts: 185
Joined: Mon Dec 08, 2008 11:52 pm
Location: Livingston,West Lothian

Re: heater not blowing to leg

Post by buddyh42 » Sun Dec 14, 2008 11:53 pm

only got her a week ago dont know if it was working on the road up from poole, but its not worked since getting her home, it is the digital one, thanks for the reply will have a look
That'll Be The Day.........


'99 Silver V6 Moonfleet Conversion
User avatar
buddyh42
Bongolier
Posts: 185
Joined: Mon Dec 08, 2008 11:52 pm
Location: Livingston,West Lothian

Re: heater not blowing to leg

Post by buddyh42 » Tue Dec 16, 2008 5:17 pm

Hi had a look and i can turn it onto my legs then onto my dash but using the switch it doesnt work,
at least i can have hot legs now :lol:
That'll Be The Day.........


'99 Silver V6 Moonfleet Conversion
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: heater not blowing to leg

Post by missfixit70 » Tue Dec 16, 2008 6:10 pm

In the picture above the actuator motor is missing ( posted the wrong piccy #-o ), top right where the connector is with nothing connected to it.

Here is what it should look like

Image

Check you've got the actuator installed & connected properly, if it all appears to be connected in the right places & still not working, check to see if it's getting any voltage coming through when you switch positions.
You can't polish a turd - but you can roll it in glitter.
Locked

Return to “Techie Stuff”