
Help.! Ive got the hold light flashing
Moderators: Doone, westonwarrior
Help.! Ive got the hold light flashing
Over the last week or so the hold light has started flashing after about 15 mins from start up with no apparent gear change issues.The fault has always cleared after the car has been stationary for a while.It started to flash this morning on my way to work,but on start up tonight its still flashing! It dont seem to engage the overdrive gear that usually kicks in a few seconds after 4th? engages.I have a 200 mile trip on Saturday.If i cant get anything sorted tomorrow,will it be ok to drive that distance without the overdrive kicking in.? 

- dandywarhol
- Supreme Being
- Posts: 5446
- Joined: Mon Dec 19, 2005 10:18 pm
- Location: Edinburgh
Re: Help.! Ive got the hold light flashing
Lots of info in search frosty but flashing hold light usually means not engaging 4th or lockup. you're liable to overheat the engine if running in too low a gear in warm temps. at speed.
Whale oil beef hooked
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
- westonwarrior
- Supreme Being
- Posts: 2918
- Joined: Thu Apr 05, 2007 6:27 pm
Re: Help.! Ive got the hold light flashing
the hold light flashing means you have gone into "get me home mode" so it can not be driven over 40mph
you can check for the fault codes a fact sheet is in members section and depending on what comes up you can decide what to do
but driving 200 miles no
you can check for the fault codes a fact sheet is in members section and depending on what comes up you can decide what to do
but driving 200 miles no
-
- Bongonaut
- Posts: 34
- Joined: Sat Mar 29, 2008 11:44 pm
- Location: Chandlers Ford, HANTS
- Contact:
Re: Help.! Ive got the hold light flashing
I doubt you would want to pay for the amount of fuel you'd use on a 200 mile trip in third gear either.
Jes.
Jes.
1995 Black FWD AFT 2.5 Diesel
Re: Help.! Ive got the hold light flashing
Thanks so much for your quick response guys!
Had the beast looked over and im very low on ATF
Have purchased said fluid from Halfords and will be gently , gently nursing it to work tomorrow to top up .After that,its fingers crossed as Im off on my hols. on Saturday morning all going well.Thanks very much again.Chris 



- dandywarhol
- Supreme Being
- Posts: 5446
- Joined: Mon Dec 19, 2005 10:18 pm
- Location: Edinburgh
Re: Help.! Ive got the hold light flashing
good news - next job - find the leak
sometimes the oil cooler pipes can leak. Remember to check the level with the engine warm, idling in "D", handbrake fully (almost typed hard
) on and wheel chocked if neccessary - after rowing it through the gears a few times.


Whale oil beef hooked
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Re: Help.! Ive got the hold light flashing
Thanks for the reply Dandy.I made a bad reading off the dipstick last night and found i was ok on the ATF levels.Just as a process of elimination,i had a complete fluid change this morning exactly as per fact sheet.Put the whole 5 litres in,then took the bongo out on the dual carriageway for half an hour at a fair pace
No problems at all.Went through the gears lovely.On the way home this evening,on comes the old hold light again
Cant get fourth anymore ,so Bongo will be sitting on my drive next week; and i,m busy making alternative holiday arrangements.I,m gutted.Thanks again folks for all the replies.Will post again on my return.Chris


Re: Help.! Ive got the hold light flashing
1. Have you got a chipped speedo (i.e. is your odometer in miles not km)?
Lots of posts here about speedo chips interfering with gearbox electrics.
2. Did you have the filter cleaned when the aft fluid changed?
Lots of posts here about speedo chips interfering with gearbox electrics.
2. Did you have the filter cleaned when the aft fluid changed?
Re: Help.! Ive got the hold light flashing
You need to read the transmission fault code -- there's a fact sheet in the members area on how to do it. I had some hold light/ safe mode experiences recently. The code was for the overrunning clutch solenoid, and with a new solenoid pack installed in the trans (£300 parts and labour) haven't had a flashing hold light since.
Re: Help.! Ive got the hold light flashing
Hi Trevd,Checked odometer,its in kph.Yes the filter was cleaned with the change this morning.
Re: Help.! Ive got the hold light flashing
Thanks everyone for your wealth of info and help.Going to check over the fault codes in a minute with me neph. and then call it a day.Im pooped! Cheers Chris
Re: Help.! Ive got the hold light flashing
Still up !Just got a fault code 63 TCC control solenoid.Any ideas anyone? 

Re: Help.! Ive got the hold light flashing
Hi all.Just checked back on some other posts,and its looking like a new solenoid pack atm.?
Re: Help.! Ive got the hold light flashing
If you're very lucky, it could be an electrical connection to the solenoid rather than the solenoid itself. You will need to find a mechanic who specializes in automatic transmissions. Where do you live? -- there may be somebody on this forum who knows a good transmission repair shop in your area.
Re: Help.! Ive got the hold light flashing
Hi again.Back from hols now and needing to sort Bongo out asap.Took a week to get booked in with local auto trans.specialists who ended up scratching their heads , so i need to find someone as local as poss. with the know how to get me sorted.Anyone know of a good place to take it in my neck of the woods?.