Technical questions and answers about the Mazda Bongo
Moderators: Doone, westonwarrior
-
brorabongo
- Supreme Being
- Posts: 3226
- Joined: Wed Jan 17, 2007 5:56 pm
- Location: Brora, Sutherland
Post
by brorabongo » Mon Sep 17, 2007 8:59 pm
Reversing the other night and could not see a thing out of the back window

Does anyone know if the lamp can be replaced by LED's, if so what fittings are they? Or from searching on here, I have see someone added lights on the bumper would this be a better idea? I already have the single fog in the rear bumber.
Cheers.
ボンゴの激怒 pictures
Run your fingers over my Bongo, and I'll run my Bongo over your fingers!!

-
missfixit70
- Supreme Being
- Posts: 12431
- Joined: Fri Jun 01, 2007 3:53 pm
- Location: weymouth
Post
by missfixit70 » Mon Sep 17, 2007 9:08 pm
brorabongo wrote: Does anyone know if the lamp can be replaced by LED's, if so what fittings are they?
Cheers.
Was thinkin the same thing, haven't got around to checkin yet, but I reckon it's a goer

You can't polish a turd - but you can roll it in glitter.
-
vanvliet
- Supreme Being
- Posts: 2081
- Joined: Tue Aug 09, 2005 6:33 pm
- Location: Fife , Scotland
Post
by vanvliet » Mon Sep 17, 2007 11:38 pm
Could you not fit a flush fit reversing lamp ( to match the fog) with LED's in addition to upgrading the cluster located reversing lamp?
-
brorabongo
- Supreme Being
- Posts: 3226
- Joined: Wed Jan 17, 2007 5:56 pm
- Location: Brora, Sutherland
Post
by brorabongo » Mon Sep 17, 2007 11:41 pm
vanvliet wrote:Could you not fit a flush fit reversing lamp ( to match the fog) with LED's in addition to upgrading the cluster located reversing lamp?
Just been quickly checking ebay for such a thing, but with no luck.
The search continues!!
What type of fitting/lamp is used for reverse?
ボンゴの激怒 pictures
Run your fingers over my Bongo, and I'll run my Bongo over your fingers!!

-
corblimey
- Supreme Being
- Posts: 14067
- Joined: Sat Dec 09, 2006 11:37 am
- Location: East Devon
Post
by corblimey » Tue Sep 18, 2007 7:35 am
Hi Brora
Try
http://www.ultraleds.co.uk they may have what you're after. If you need bright look out for ones that use high power leds(1W and above) e.g. Luxeon stars or similar. They're fairly easy to spot since they usually have a heat sink built into the body. The obvious dowside is that they run very hot.
-
vanvliet
- Supreme Being
- Posts: 2081
- Joined: Tue Aug 09, 2005 6:33 pm
- Location: Fife , Scotland
Post
by vanvliet » Tue Sep 18, 2007 5:58 pm
Flush fit reversing lamp to match the fog ( uses same housing but with a clear lense - fits to LHS of bumper) from Far East Services £10 plus post plus the dreaded VAT
http://www.importedvehicles.co.uk/
-
missfixit70
- Supreme Being
- Posts: 12431
- Joined: Fri Jun 01, 2007 3:53 pm
- Location: weymouth
Post
by missfixit70 » Tue Sep 18, 2007 11:29 pm
Haven't checked the bulbs yet, but check out "jzautoled" on ebay, seems to stock just about any led replacement bulb, same guy I bought my internal leds from I think.
You can't polish a turd - but you can roll it in glitter.
-
vanvliet
- Supreme Being
- Posts: 2081
- Joined: Tue Aug 09, 2005 6:33 pm
- Location: Fife , Scotland
Post
by vanvliet » Sat Sep 22, 2007 6:14 pm
Seems a bit overkill compared to £14 for a flush fit reversing lamp - but - - they look great - surely cost an arm and a leg though !
Doesn't say how they are mounted -are they flush fit? Is there space behind the bumper ? - probably yes . The 'rib' running along the middle of the bumper is 80mm - they would just overlap this by 3 or 4 mm top and bottom - how would this going to affect a neat flush fit /seal?
-
brorabongo
- Supreme Being
- Posts: 3226
- Joined: Wed Jan 17, 2007 5:56 pm
- Location: Brora, Sutherland
Post
by brorabongo » Sat Sep 22, 2007 6:57 pm
Did'nt manage to find a price for them

. Take it they are expensive then!!

ボンゴの激怒 pictures
Run your fingers over my Bongo, and I'll run my Bongo over your fingers!!

-
bigdaddycain
- Supreme Being
- Posts: 10637
- Joined: Fri May 13, 2005 11:58 am
- Location: Ince Lancs
Post
by bigdaddycain » Mon Sep 24, 2007 1:53 pm
Hmm, they look good brora...
I had the same problem as you with regards to rearward visibility.
I adapted mikeonb4c's concept of flush fitting fogs, to flush fitting clears, I just remove the clear bulbs at m.o.t. time, and replace with red bulbs.
So i have the option of 4 reverse lights when the need arises

ビッグダディケイン RIP Big Bank Hank (Imp the Dimp) 1957-2014
-
MountainGoat
- Supreme Being
- Posts: 3945
- Joined: Sat Jan 13, 2007 10:12 pm
- Location: Scottish Borders
Post
by MountainGoat » Mon Sep 24, 2007 2:03 pm
Hey Bigdaddy,
How do you adjust the lighting to the fact that the clear lamps are only supposed to come on when you are reversing and the red lamp on when you are going forward in fog.
-
bigdaddycain
- Supreme Being
- Posts: 10637
- Joined: Fri May 13, 2005 11:58 am
- Location: Ince Lancs
Post
by bigdaddycain » Mon Sep 24, 2007 2:18 pm
Simple MG,...The switch and wiring remain unaltered, the factory fit reverse lights illuminate as reverse is engaged,then i click the "foglight" switch if extra illumination is neccessary.
I make sure i always carry the red bulbs in the glovebox, just in case of a sudden "peasouper" but, i have been lucky so far, as i've only needed to swap over the bulbs for the m.o.t.

ビッグダディケイン RIP Big Bank Hank (Imp the Dimp) 1957-2014
-
vanvliet
- Supreme Being
- Posts: 2081
- Joined: Tue Aug 09, 2005 6:33 pm
- Location: Fife , Scotland
Post
by vanvliet » Mon Sep 24, 2007 6:32 pm
If you wanted to go overboard you could fit three flush fit lamps on the rear bumper - two reversing and one fog!!
-
waycar8
- Supreme Being
- Posts: 3037
- Joined: Fri Mar 17, 2006 9:35 pm
- Location: west yorkshire
Post
by waycar8 » Mon Sep 24, 2007 7:58 pm
or you could make the wife get out and watch you back up
and if the wife isnt available ask a passer by
