Did you mean non specific Bongo switches....? If so, this may help..? http://www.igmaynard.co.uk/bongo/forum/viewtopic.php?f=3&t=24573&hilit=mx3+drivers+window+switch

Thanks Jaylee

Yes my switch is definitely broke, local Bongoer lent me his switch to try and all working ok all i need now is a ...

Is it possible to use aftermarket electric window switches ? Available on ebay for a fraction of the original cost.

Has anyone done this and how hard is it ?

Thanks for that everyone , seems the bulb must be gone.

I have spotted a green light today just above the rear heater controls, never seen it before whats it for and what does it do ?

Thanks

Gerald

Hi

Try spraying loads of electrical contact cleaner ( available from Halfords for approx £3.99 for a large tin! ) all over the motor ect. I've had no ends of 'stuck' electrics on our Bongo .... horn press's / rear blind switches to name a few .... all working 100% now thanks to a quick spray with ...

My driver window was working intermitantly but has now stopped altogether.

Have checked the wiring and all seems well, getting power to the electric motor connector but the motor not working.

Is there a fix for this

Thanks in advance

I didn't want to add to the confusion until you got it running, but now you have, keep an eye on the back of the pump where you first saw the fuel drip because the seals you have replaced may not be the full story.

There is an internal seal between the pumping section of the pump and the ...

Bongo running like new. :D :D :D :D :D :D :D :D :D :D :D :D :D :D

I connected an air powered brake bleed vacuum to the pipe that returns fuel to tank and bobs your uncle.

Seems like there was air in there that could not get out.

I will take her for a run tonight to try her out.

Thanks to all ...

Is there any way to pressurise the fuel tank to force the diesel through?

As far as i know the seals were not pinched on reassembley.

And the spring and shims were put back exactly as removed.

The fuel stop solenoid has 10.3volts going to it ( does that sound right ) when the ignition is switched.

I can feel the solenoid click when ignition is switched on.

What if i ...

Ok i surrender :cry: :evil: :cry: :evil:

This Bongo dont want to start.

Have put new filter on filled with diesel, cleaned the small wire mesh strainer on the fuel input.

Fully charged battery but this baby dont want to go.

And it all started with me changing the two o rings on the pump to cure ...

Yes I have given it some gas but still no start.

No I have not got a pela pump but hope to get it going in the morning.

As far as i know there is no immobiliser or alarm system.

Just checked fuses all seem ok, all cabin lights working (fuse no1 10 amp)
Engine management ( fuse no 9 15 amp)
Will sleep on it and have another go tomorrow.

Thanks for your suggestion

New solenoid fitted Bongo still no play.

Battery flat now , on charge start again tomorrow.

Thanks all