Bongo Fury

Hi,

I'm having a few issues with my temperature gauge. Actual vehicle cooling is fine but gauge is messing about.
If you fit a third-party gauge, where is the best place to fit the sensor?

Please see my other post if you fancy helping out with the factory gauge issue too

Cheers.
Mark

Doesn’t really matter where you fit it….not near the exhaust or in the air floe…the back of the cylinder head is ba good spot…..fit it, drive around for a couple of days and note the “normal” reading on the gauge and the highest temp achieved….set the alarm a couple of degrees higher than the highest reading…( up hill under power)