Bongo Fury

Posted: **Tue Nov 26, 2019 2:11 pm**

Hi, I am trying to replace my gear shift unit. It seems easier to replace the whole unit than fiddling around with the knob and gear indicator sheet thingy.
I got everything undone but then got to a clip (about an inch square) that holds the cable into the unit.
Can anyone tell me how to get this off please? In such a way as for it to be usable again for the replacement?
Thanks loads for any help

Posted: **Tue Nov 26, 2019 5:10 pm**

plonkatronix wrote: Tue Nov 26, 2019 2:43 pm Large black U shaped one? said clip slides out to the back if I remember correctly, flat head screwdriver for leverage maybe

Sorry, it's not black, and it comes out toward pas side

[http://imgur.com/gallery/5fURV9o]

Posted: **Tue Nov 26, 2019 5:11 pm**

HappyCamper wrote: Tue Nov 26, 2019 5:10 pm
plonkatronix wrote: Tue Nov 26, 2019 2:43 pm Large black U shaped one? said clip slides out to the back if I remember correctly, flat head screwdriver for leverage maybe

Sorry, it's not black, and it comes out toward pas side

[http://imgur.com/gallery/5fURV9o]
Thank you the picture shows what I was referring to. Is that what you meant too?

Bongo Fury

Gear shift unit change - help

Gear shift unit change - help

Re: Gear shift unit change - help

Re: Gear shift unit change - help