Bongo Fury

Hi guys,

I've been unable to source the no1. exhaust gasket directly leading off from the turbo (KL1540305)

Does anybody know if the no2. will do the job? (WL0140305)

http://lushprojects.com/bongopartsmk2/c ... no=.html#9

Thanks

I used the same crush washers throughout my exhaust. They were thrown in by bongospares with a secondhand downpipe so no idea about part numbers.

G-meister wrote:Hi guys,

I've been unable to source the no1. exhaust gasket directly leading off from the turbo (KL1540305)

Does anybody know if the no2. will do the job? (WL0140305)

http://lushprojects.com/bongopartsmk2/c ... no=.html#9

Thanks

Could you pop down to your local Quack Fit and ask them to match it?

Thanks for the info Chris,

I would get it matched but it's still in place until the garage looks at it.

G-meister wrote:Thanks for the info Chris,

I would get it matched but it's still in place until the garage looks at it.

Sorry. I thought you were doing t yourself.
I would think the garage would just send it off to get it matched by their factors.
Probably the same as the Ranger I would guess.
If you could get the part number they use it could be a useful addition to the parts cross over DB on here.
Good Luck.

Think they call it a squash ring gaskey
Every auto spates shop sells them
Halfords will do for deffo just measure diameter
And order of eblay

OK great, thanks for your help all

Wooden ruler measurements of the washer (Not crushed) in the pic I posted earlier:
OD 68.5mm
ID 56mm
Thickness 6mm-6.5mm approx.

You should be able to get gaskets from your local Harrods .

http://bongoland.co.uk/product/exhaust-gasket-bolt-set/

And

http://mazdabongo.com/catalog/mazda-bon ... all-model/


Good Luck.