Bongo Fury

I got an advisory on the MOT: "Anto roll bar linkage has slight play in pin/bush nearside rear."

Is this a diy or garage job? (Any special tools needed?)

Which parts am I likely to need?

I assume I should do both sides at the same time.

Ta in advance.

heres the back axle.

http://lushprojects.com/bongopartsmk2/c ... 1of02.html

heres the anti roll bar and drop links, i presume he meant the bolts that go through the drop links, the little bushes that are at each end of the drop links wear badly, mumber 2b-170b on the drawing. (get gen mazda ones not cheap ones)

http://lushprojects.com/bongopartsmk2/c ... mgno=.html