Bongo Fury

I have a 2WD Bongo that I am currently swapping the "Good Bits" onto my other Bongo.
I have removed the left had hub.
Does the 2WD hub have splines within it to take the CV joint of a 4WD.
I have managed to undo the very very tight blanking nut and it appears to have a shaft pressed into the hub.
I do not want to waste my time trying to remove this shaft to find that it does not have the splints.
There is a female thread on the outer side, I am wondering if this is just cap and screwing in a bolt will remove this and then shaft can be pressed out.

does this help.

http://lushprojects.com/bongopartsmk2/c ... mgno=.html.

http://lushprojects.com/bongopartsmk2/c ... mgno=.html


look like its a goer to me.

It looks like the hubs carry a different part number, the rest of the assy should be interchangeable, why do you want to change (swap)the hubs.?

Good Luck

rita wrote:It looks like the hubs carry a different part number, the rest of the assy should be interchangeable, why do you want to change (swap)the hubs.?

Good Luck

There is no brake disc shield on the right hand side of my 4WD Bongo.

Looks like it is a press fit on the hub.

Was just looking to use the hub from the 2WD