Bongo Fury

i've not factory fog lights (neither has bongo)
so bought some ring fog lights to fit the hole, looked at bongo and searched forum
still got questions
1 physical connection:
Now as to physicaly mounting them. There is no solid metal work to mount to.
Do i just drill a hole in the plastic work, hanging the assembly from the roof of the lamp orrifice or some other clamping method. the sides seem more solid

2 electrical:
I have 3 relays, hidden wiring on rhs by steering wheel include 2 plugs one with red/white wire tother with black yellow


do i need an origional switch with existing loom or how to use a 3 wire switch (iluminated as supplied with kit)
do i forget wiring loom and do it fresh

I have the same problem re not having any
Fog lights on the front. What lights did you buy
Please, and where from? Thanks in advance.

THese from Halfords
http://www.halfords.com/webapp/wcs/stor ... yId_272450

currently includes relay, switch, wire and fuse
mounting I'm not sure thats why asking for advice

I used the ring ones on my last Bongo, they fitted fine i just made some brackets and used the small holes in each corner of the foglight hole on the bumper to fasten them on.

thanks
stuc
thinking about 2 straight plates corner to corner in X pattern.

Ignore the red lines, but the original brackets can be seen in the middle:



The larger outer holes fit to the bumper while the smaller ones were for the screws that went into the rear of the lamp. You could just get a piece of black plastic, drill 4 holes to suit the bumper mounting points and then fit the lamp to the front.