Page 1 of 1

enging not starting

Posted: Sat Jun 29, 2013 10:16 pm
by matt whu
help just changed fuel filter re started engine ran for a while then stopped. took filter off again no fuel in filter any ideas :?:

Re: enging not starting

Posted: Sat Jun 29, 2013 10:33 pm
by haydn callow
Did you fill the new filter with fuel before fitting?

Re: enging not starting

Posted: Sat Jun 29, 2013 10:56 pm
by Driver+Passengers
If your fuel filter body does not have a primer pump on the top (lots don't), then it can take a full minute or more of cranking to start with a dry filter. Filling with fuel first should reduce the time.

Re: enging not starting

Posted: Sat Jun 29, 2013 11:00 pm
by matt whu
haydn callow wrote:Did you fill the new filter with fuel before fitting?
no ,have change filter many times befor and never filled with fuel befor

Re: enging not starting

Posted: Sat Jun 29, 2013 11:23 pm
by Simon Jones
Diesel or petrol? If the former, keep spinning it over on the starter and assuming you don't have a leak around the filter seal, it should eventually start. If petrol, turn ignition on and off a few times to allow the fuel pump to repressurise the fuel lines.

Re: enging not starting

Posted: Sun Jun 30, 2013 12:58 pm
by matt whu
Simon Jones wrote:Diesel or petrol? If the former, keep spinning it over on the starter and assuming you don't have a leak around the filter seal, it should eventually start. If petrol, turn ignition on and off a few times to allow the fuel pump to repressurise the fuel lines.
put disel in filter now runs should have known better

Re: enging not starting

Posted: Sun Jun 30, 2013 6:49 pm
by Simon Jones
I guess you have a diesel engine then :wink:. Glad it's all sorted now. For next time, fill the empty filter with some injector cleaner to give the system a good clean out when it starts up.