Page 1 of 1

I have no flashers

Posted: Thu Apr 18, 2013 7:52 pm
by alan
seem to have lost all indicator and hazzards light think it might be a fuse but which one plase #-o #-o

Re: nhave no flashers

Posted: Thu Apr 18, 2013 8:05 pm
by g8dhe
Bongo Wiring Manuals are on line here http://www.g8dhe.net/bwm/
But the fuses will be;
Image

Re: nhave no flashers

Posted: Thu Apr 18, 2013 8:06 pm
by alan
g8dhe wrote:Bongo Wiring Manuals are on line here http://www.g8dhe.net/bwm/
But the fuses will be;
Image
thank you

Re: nhave no flashers

Posted: Thu Apr 18, 2013 8:14 pm
by jaylee
g8dhe wrote:Bongo Wiring Manuals are on line here http://www.g8dhe.net/bwm/
But the fuses will be;
Image
The one highlighted is for the hazards... The 10amp red fuse on the row below, 3rd from the left is for the indicators.


Re: I have no flashers

Posted: Fri Apr 19, 2013 5:01 pm
by alan
#-o #-o tryed put new fuse in but there just blowing as i puting them in hlep want next

Re: I have no flashers

Posted: Fri Apr 19, 2013 5:05 pm
by Driver+Passengers
Have you got a multimeter? You may not need one but it might be an easier fix if you do. You can get one <£10 if there's a Maplin nearby or borrow off a neighbour.

Re: I have no flashers

Posted: Fri Apr 19, 2013 5:08 pm
by alan
Driver+Passengers wrote:Have you got a multimeter? You may not need one but it might be an easier fix if you do. You can get one <£10 if there's a Maplin nearby or borrow off a neighbour.
yeh loks like iam going to have to fine one or buy one but do the wires goi thought he door ??????? is it time to have a look at the door loom

Re: I have no flashers

Posted: Fri Apr 19, 2013 5:13 pm
by Driver+Passengers
alan wrote:
Driver+Passengers wrote:Have you got a multimeter? You may not need one but it might be an easier fix if you do. You can get one <£10 if there's a Maplin nearby or borrow off a neighbour.
yeh loks like iam going to have to fine one or buy one but do the wires goi thought he door ??????? is it time to have a look at the door loom
I can't imagine why they would.

Which fuse is blowing? Both of those mentioned above? You've probably got a short to ground.

I'm not up to speed with the light clusters, but if you can get the connectors removed from the indicator bulb holders and still blow a fuse, you can discount bulb holders and start looking at the wiring. If you've identified the right connectors, then you can start following whatever exposed wiring there might be.

Just an idea - not the 'right way' to go about diagnosing necessarily, but it's where I'd maybe start if I was faced with the same.

Re: I have no flashers

Posted: Fri Apr 19, 2013 8:17 pm
by Hanksy
alan wrote:seem to have lost all indicator and hazzards light think it might be a fuse but which one plase #-o #-o

make sure you are not blinking at the same rate as the lights :lol: :lol: :lol:

Re: I have no flashers

Posted: Fri Apr 19, 2013 8:40 pm
by the laird
Take all bulbs out ,2 put indicators on and refit bulbs one at a time then see when it blows with which bulb done it,just a quick wy o pinpoint source then check those wires,hope this helps a bit

Re: I have no flashers

Posted: Sat Apr 20, 2013 7:15 am
by jaylee
Do you have towing electrics fitted??

Re: I have no flashers

Posted: Sat Apr 20, 2013 9:28 am
by alan
jaylee wrote:Do you have towing electrics fitted??
yes

Re: I have no flashers

Posted: Sat Apr 20, 2013 11:40 am
by alan
alan wrote:
jaylee wrote:Do you have towing electrics fitted??
yes
thank you for the pionters truned out to be tow bar wiring all soted cheers