Page 1 of 1
Stalling on setting off
Posted: Tue Nov 22, 2011 11:10 am
by al & chris
Just had bongo serviced and had new plugs put in. Now from a cold start in a morning bongo stalls when setting off. Starts fine no smoke etc and will go ok if run for a minute before setting off. All other times starts fine even after several hours at work. It has never done this before, could one of new plugs be fualty. 2.5 TD automatic.
Any ideas
Al
Re: Stalling on setting off
Posted: Tue Nov 22, 2011 11:19 am
by wonkanoby
is the cold start working
ie were it over revs for the first few minutes then drops back to regular idle
Re: Stalling on setting off
Posted: Tue Nov 22, 2011 1:34 pm
by al & chris
Thanks think it is that . We had a new rocker cover gasket put on as well. Maybee something is not connected back together properly.
Re: Stalling on setting off
Posted: Tue Nov 22, 2011 1:41 pm
by wonkanoby
thats very possible
the solenoid bits work it are to rear of engine on a bracket on drivers side
http://www.igmaynard.co.uk/bongo/forum/ ... +fast+idle
there is a good picture in there black and white bits with wires plugged to them
Re: Stalling on setting off
Posted: Thu Nov 24, 2011 11:59 pm
by al & chris
Strange looks like its cured its self. Not got to look at it yet but all apears to be ok now!
Re: Stalling on setting off
Posted: Fri Nov 25, 2011 9:35 am
by wonkanoby
turning on a/c should also cause throttle to pick up and idle to rise
might be enough to eleviate the situation on a temp basis