MAZDA RX8 ALLOYS

[TEZ217]

Hi,
Getting a set of RX8 Alloys for my Bongo do I need different studs/nuts to fit them any help most welcome

[apole]

Hi there,

I didn't, changed mine from steels to RX8 and the original nuts were fine. Recommend you get locking wheel nuts and if your old nuts are rusty get some covers for them, far cheaper than new nuts that will probably rust anyhow.

Andy

[Triple/R]

Hi there,

I didn't, changed mine from steels to RX8 and the original nuts were fine. Recommend you get locking wheel nuts and if your old nuts are rusty get some covers for them, far cheaper than new nuts that will probably rust anyhow.

Andy

Eyup Andy---i'm going that route (when funds allow) whats these nut covers??--cheers

[francophile1947]

Eyup Andy---i'm going that route (when funds allow) whats these nut covers??--cheers

See here http://www.pabo.com/product/details/505 ... 4wodriCA5w or here http://www.antipit.co.uk/

[Triple/R]

Eyup Andy---i'm going that route (when funds allow) whats these nut covers??--cheers

See here http://www.pabo.com/product/details/505 ... 4wodriCA5w or here http://www.antipit.co.uk/

thanks John--looks good to me but i do'nt think Christine would be too impressed (especially with my body)

[TEZ217]

Thanks for that Andy, and for the selection of NUT COVERS!!

[bigdaddycain]

I used something like this....

http://cgi.ebay.co.uk/20-Genuine-mazda- ... 27afc687ee

My missus said my old nuts were a bit pathetic,said she'd seen some much better nuts around the time, so i asked her to get her hands on em for me.

[apole]

I used the antipit ones, they work well and are holding up well too, still look like new. They are a very snug fit so I used a little light grease on the insides to make removal easier later on.