Body panels or panel beating after hit and run.

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Post Reply
nigelginny

Body panels or panel beating after hit and run.

Post by nigelginny » Sun Nov 15, 2009 12:23 pm

Hi, some one hit and ran my beast (i know who but they wont admit it :evil: ), damaged the rear near side next to the fuel filler cap, anyone know if the panel is replaceable?
shes going in for a replacement cambelt on wednesday, so i am going to ask if they can repair the damage, but i was wondering what they might do, panel beat or replace?
Thanks in advance
Last edited by nigelginny on Sun Nov 15, 2009 1:04 pm, edited 1 time in total.
rita
Supreme Being
Posts: 3286
Joined: Tue Sep 15, 2009 7:11 pm

Re: Body panels

Post by rita » Sun Nov 15, 2009 12:46 pm

nigelginny wrote:Hi, some one hit and ran my beast (i know who but they wont admit it :evil: ), damaged the rear near side next to the fuel filler cap, anyone know if the panel is replaceable?
shes going in for a replacement cambelt on wednesday, so i am going to ask if they can repair the damage, but i was wondering what they might do, panel beat or replace?
Thanks in advance
Hi,sorry to hear about your bump,any decent panel beater should be able to pull out the bash.

If you report this to the Police as a hit and run they can often match the paint work from both cars.(if they left any)

Ps the fuel filler cap on a diesel is on the off-side.(if it is a diesel).
nigelginny

Re: Body panels

Post by nigelginny » Sun Nov 15, 2009 12:56 pm

Thankyou, yea its the offside :oops: ive spoken to my insurance co and they will be dealing with them, it was a white transit that was delivering accross the road from us, it has left some paint marks on our van.
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: Body panels or panel beating after hit and run.

Post by missfixit70 » Sun Nov 15, 2009 2:05 pm

Other than getting a section of panel cut from a scrapper, you'd have to replace that entire side panel I think, hope you get it sorted ok.
You can't polish a turd - but you can roll it in glitter.
dvisor
Supreme Being
Posts: 1311
Joined: Wed Sep 03, 2008 12:58 pm

Re: Body panels or panel beating after hit and run.

Post by dvisor » Sun Nov 15, 2009 2:33 pm

Sorry to hear that. I once had a mobile library reverse into my parked car and made a right mess of it. No-one around to see what happened. Another Hit & run - but they had no choice but to admit it when I pointed out the paint marks left on mine - not many nauseous lime green vehicles out there :lol:
Two tonne tin drum
User avatar
dom_e
Tribal Elder
Posts: 880
Joined: Mon Sep 22, 2008 9:55 pm
Location: Cardiff

Re: Body panels or panel beating after hit and run.

Post by dom_e » Sun Nov 15, 2009 7:38 pm

How sad. There are precious few decent people left it would seem. I hope you get it sorted and the person who caused the damage gets caught.
Beyond A to B
nigelginny

Re: Body panels or panel beating after hit and run.

Post by nigelginny » Sun Nov 15, 2009 8:32 pm

Thanks guys, ive reported it to the police now, glad that we are fully comp, i think as was said, a panel beater should be able to knock it back into shape, we are pretty lucky as our mechanic owns a bongo, he bought it as an insurance write off so if anyone knows how to repair it he will.
karlos

Re: Body panels or panel beating after hit and run.

Post by karlos » Sun Nov 15, 2009 9:33 pm

how bad is it - some times they can pull dents out, even if its still a tad out of shape it may be repairable with out removing the pannel if your going to pay for it, some times they use a slide hammer/dent removal tool -drill a small hole and give it a yank - just like the sophisticated scum bags do on crime watch to get the ignition barrel out.

usually though if it goes through the insurance they make a big song and dance, probably replace the whole pannel -this is why a lot of minor crash damage become written off - perhaps they will even quote to repray the whole thing and do several other cars within the same budget / time as fixing yours.

Sorry I had a mint van written off earlier this year - was quite bad but even so -insurance work pricing is definitely sky high.
karlos

Re: Body panels or panel beating after hit and run.

Post by karlos » Mon Nov 16, 2009 9:17 am

oh and please beware - Your mechanic might be a great mechanic and might be a great painter too but

(I ocassionally paint race cars on fresh body work(would not advertise it)- but I'm not a painter im a really elctro mechanical engineer -repairs etc are much harder, mixing paints,even the codes dont always come out quite right,metalics are a pain)

1)I tried to do a repair to the mrs mgtf sill as it was so low down/not so noticeable -metalic silver,nightmare(was a blow in job)paint was matched to colour codes, with metalic the more coats that go on the colour looks deeper/darker. I had to take it to my friends paint shop as I just couldnt get it spot on.

2)My dad had his new wing painted on his car by his mechanic and it looked s##t wrong colour/tone and the finish was terrible. The mechanic obviously knew nothing about flatting and polishing. This mechanic preps and paints other cars with no compressed air filtration,heat, no polishing mops or proper da's etc. He once preped a car that went to a proper paint shop for a translucent paint -multi layed,one that changes colour and they refused to paint it.

Thats not to say your man isnt top notch but I would beware if he doesnt have a spray booth and mixing room -he's not that serious.

I appreciate any one used to a bongo can probably strip it with more finesse, but most spray shops are used to stripping a whole range of vehicles from corsa's to porsches-if this is there job one vehicle is not that different to another!(general speaking-obviously there are differences)

Take it to a specialist unless you really know have seen this chaps work. Painting is not black magic -but it can be querky and the experts are the experts. "It sounds like you care about your bongo.
rita
Supreme Being
Posts: 3286
Joined: Tue Sep 15, 2009 7:11 pm

Re: Body panels or panel beating after hit and run.

Post by rita » Mon Nov 16, 2009 2:57 pm

dvisor wrote:Sorry to hear that. I once had a mobile library reverse into my parked car and made a right mess of it. No-one around to see what happened. Another Hit & run - but they had no choice but to admit it when I pointed out the paint marks left on mine - not many nauseous lime green vehicles out there :lol:
Hi,did the police BOOK them. :)
dvisor
Supreme Being
Posts: 1311
Joined: Wed Sep 03, 2008 12:58 pm

Re: Body panels or panel beating after hit and run.

Post by dvisor » Mon Nov 16, 2009 3:00 pm

rita wrote:
dvisor wrote:Sorry to hear that. I once had a mobile library reverse into my parked car and made a right mess of it. No-one around to see what happened. Another Hit & run - but they had no choice but to admit it when I pointed out the paint marks left on mine - not many nauseous lime green vehicles out there :lol:
Hi,did the police BOOK them. :)
No, but it was a novel accident
Two tonne tin drum
MondoBongo

Re: Body panels or panel beating after hit and run.

Post by MondoBongo » Mon Nov 16, 2009 3:09 pm

rita wrote:
dvisor wrote:Sorry to hear that. I once had a mobile library reverse into my parked car and made a right mess of it. No-one around to see what happened. Another Hit & run - but they had no choice but to admit it when I pointed out the paint marks left on mine - not many nauseous lime green vehicles out there :lol:
Hi,did the police BOOK them. :)

phew,, lucky I read down the rest of the thread before I cracked that one myself....
scanner
Supreme Being
Posts: 7247
Joined: Wed Sep 19, 2007 10:20 pm
Location: Cambs

Re: Body panels or panel beating after hit and run.

Post by scanner » Mon Nov 16, 2009 3:45 pm

If the mobile library hadn't had a hardback it might not have caused so much damage.
nigelginny

Re: Body panels or panel beating after hit and run.

Post by nigelginny » Wed Nov 18, 2009 7:21 pm

Just a quick update, we had the cambelt and adjuster replaced today, the garage guys said it looks like the damage should come out ok, the insurance co are gonna have one of their approved garages do the repair, i was going to add some pics of the damage but i couldnt get it to work #-o
Post Reply

Return to “Techie Stuff”