Bongo Fury

How do you replace the lamp in the hazard light switch? Can't find how to remove switch. Thanks in anticipation

with great difficulty you can prise it out but the wires are cable tied to the back of the dash. Think I did mine when I swapped the radio and heater controls around gave me a bit more room to get in and cut the cable tie.
Hope this helps

If I remember right it's got clips that need to be pushed in top & bottom, I think I used a butter knife, but it was a bit of a 'mare to get out

Thank you both I'll give it a whirl

i managed to remove the switch,but it looked fiddly to take apart,and i left it for now
jamie

the bulb is just accessed from the side I think, no need to take it apart, turn it 90 degrees with a diddly screwdriver & it should pop out.

thanks kirsty.i will have a look on saturday.
jamie

Curiously, the light in my hazards stopped working when the illumination in the lower bank on the heater packed up...

Sounds like i'll have fun replacing those bulbs then...