Drivers Windows - stopped working

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Post Reply
fergusminto
Junior Bongonaut
Posts: 14
Joined: Mon Oct 03, 2011 1:47 pm
Location: Scottish Borders

Drivers Windows - stopped working

Post by fergusminto » Thu Apr 21, 2016 12:46 pm

Before I delve into the wiring, thought I would ask if anyone had the same prob? Passenger side window works fine from the passenger door switch but on the drivers side nothing works. I haven't done anything recently to precipitate such a prob so any ideas? Rather not start taking the wiring loom apart! Is it the same fuse for both R and LH windows? Can the switch fail for both sides at the same time? Thanks.

I should add that the passenger widow "cut-off" switch on the Driver's side still works!
Last edited by fergusminto on Thu Apr 21, 2016 1:14 pm, edited 1 time in total.
User avatar
g8dhe
Supreme Being
Posts: 10701
Joined: Sun Apr 13, 2008 10:06 pm
Location: Worthing, West Sussex.

Re: Drivers Windows - stopped working

Post by g8dhe » Thu Apr 21, 2016 12:50 pm

Its very rarely the fuses, the switch and loom are the two most common items to fail, you can check the fuses on the Wiring Site bit I would lay odds on it being the switch or loom!
Geoff
2001 Aero V6, AFT, full side conversion.
fergusminto
Junior Bongonaut
Posts: 14
Joined: Mon Oct 03, 2011 1:47 pm
Location: Scottish Borders

Re: Drivers Windows - stopped working

Post by fergusminto » Thu Apr 21, 2016 1:18 pm

Thanks for the speedy reply. Will check fuses first then switch. Not looking forward to wiring though!

Regards
fergusminto
Junior Bongonaut
Posts: 14
Joined: Mon Oct 03, 2011 1:47 pm
Location: Scottish Borders

Re: Drivers Windows - stopped working

Post by fergusminto » Thu Apr 21, 2016 1:34 pm

Thanks. Shorted out D and H wires in the switch plug which should open the window but nothing. Power feed wire may be broken? I will take door panel off and check motor just in case.

Regards
User avatar
Muzorewa
Supreme Being
Posts: 5250
Joined: Wed Sep 19, 2007 6:00 pm
Location: Team Muz HQ, Outer Bongolia
Contact:

Re: Drivers Windows - stopped working

Post by Muzorewa » Thu Apr 21, 2016 1:35 pm

The wiring is easy enough to access, it's normally the bit of the loom between the door & the body so you don't have to strip anything apart to get to it. The break in the cable will normally be at the bottom of the U where it's attached by a plastic clip, not where it comes through the grommets in the door or body. You'll need to remove the clip (probably breaking it but no bother) then slice through the corrugated sheath to get to the individual wires. Once there the problem should be self-evident. Good luck :wink:
Image
Post Reply

Return to “Techie Stuff”