Have recently purchased a new shape bongo 2.5 V6. It's a V reg with low mileage and drives well. However, when reversing up my drive it keeps stalling. I am reversing at low revs as it is a tight turn at the top of the drive. Doesn't stall at all in forward gears. Any ideas. It has been sitting idle for the best part of a year so does it just need a full service?
Grateful for any help as a newly fledged bongonaut! Cheers
Stalling in Reverse
Moderators: Doone, westonwarrior
-
BongoBuds
-
Simon Jones
- Supreme Being
- Posts: 9341
- Joined: Mon Aug 29, 2005 3:34 pm
- Location: Salisbury (ish), Wiltshire
Re: Stalling in Reverse
Auto or manual? The V6 lacks the low down torque of the diesel, but I've never had any problems getting mine up hills in either direction. Does it restart ok after it's stalled? Perhaps the fuel in the tank is low so it's sloshing away from the pick up pipe?"
-
BongoBuds
Re: Stalling in Reverse
It is an auto. It doesn't generally have a problem going uphill and starts no problem straight after a stall. Tank is almost half full so don't think it is a fuel problem. It seems to go too fast when I depress the accelerator or stalls when trying to reverse gently up or down the drive. Have to have one foot on brake and other on accelerator to control the speed. Hope his further info helps with suggested diagnosis and thanks for suggestions so far.
Re: Stalling in Reverse
Would this symptom occur after a cold start & while the engine is not fully up to temperature perchance...?
Cheaper by comparison to a race horse...
-
BongoBuds
Re: Stalling in Reverse
Yes it is generally on cold start but was also doing it after 15 mins but on a cold day.
Re: Stalling in Reverse
Take your foot off the brake.BongoBuds wrote:It is an auto. It doesn't generally have a problem going uphill and starts no problem straight after a stall. Tank is almost half full so don't think it is a fuel problem. It seems to go too fast when I depress the accelerator or stalls when trying to reverse gently up or down the drive. Have to have one foot on brake and other on accelerator to control the speed. Hope his further info helps with suggested diagnosis and thanks for suggestions so far.
you should only need the accelerator to control the speed on an automatic unless the tick over is set too high,or the accelerator is sticking.-
BongoBuds
Re: Stalling in Reverse
Yes I realise that, I was using the brake as I couldn't control the speed with the accelerator only.
Could the throttle behave differently in reverse than in forward gears e.g. sticky?
Could the throttle behave differently in reverse than in forward gears e.g. sticky?
-
Simon Jones
- Supreme Being
- Posts: 9341
- Joined: Mon Aug 29, 2005 3:34 pm
- Location: Salisbury (ish), Wiltshire
Re: Stalling in Reverse
The direction of travel wouldn't make any difference. Another thought: do you have the air conditioning running when you're having this problem? It adds quite a load on the engine and if you're not able to give it any welly going backwards, perhaps the revs are dropping to low?BongoBuds wrote:Could the throttle behave differently in reverse than in forward gears e.g. sticky?
-
mikeonb4c
- Supreme Being
- Posts: 22877
- Joined: Sun Nov 05, 2006 10:49 pm
- Location: Living with Mango Bongo in the North West but with a tendency to roam
- Contact:
Re: Stalling in Reverse
Is there no possibility that gearbox drag could differ between D and R ?Simon Jones wrote:The direction of travel wouldn't make any difference. Another thought: do you have the air conditioning running when you're having this problem? It adds quite a load on the engine and if you're not able to give it any welly going backwards, perhaps the revs are dropping to low?BongoBuds wrote:Could the throttle behave differently in reverse than in forward gears e.g. sticky?
