Help needed roof tent issue,,

[Barrington]

Hi guys need a bit of your advice of late my roof wont go to its stop position it goes all the way to the top but wont stop bleeping untill i give it the extra shuv to the last inch or so then bleep stops,, is ther anything that needs adjusting to reset the stop position? many thanks barrington,

[daveblueozzie]

Join the club loads of us have the same problem its just a small inconvenience.

[Wicker Man]

Try unzipping the tent front a little before you lower it. It helps to expel the air, but it also means that there's a slightly less strain when you open it next time.

[missfixit70]

A bit of lube on the moving bits may help too.

[Barrington]

so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

[dandemann8]

so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

It's the weight of all that "BLING" holding it down

[missfixit70]

tent fabric being stiff after a long cold winter? mechanism needs lubing therefore a bit more friction for the motors to overcome? motors getting a bit older?

[bongobaz]

A bit of lube on the moving bits may help too.

Tried that made mine even stiffer

[dandemann8]

A bit of lube on the moving bits may help too.

Tried that made mine even stiffer

Baz what you like

[bongobaz]

I know . i've just finished work too

[mister munkey]

Try a bit ot this



In the runners & rams a couple of times a year.

Works for me.

[Barrington]

so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

It's the weight of all that "BLING" holding it down

[Barrington]

Ok chris thanks mate will give it a shot, so nothing to adjust then?

[mister munkey]

I.m sure technical adjustments are available but in the early stages of Middle Aged Sticky Roof Syndrome the spray works for me,

[missfixit70]

Ok chris thanks mate will give it a shot, so nothing to adjust then?

I think one or two have found a microswitch has moved slightly? A search may find an answer