Big Draught in passenger foot well

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Post Reply
Mattsonics

Big Draught in passenger foot well

Post by Mattsonics » Sat Mar 13, 2010 9:05 pm

Been meaning to get to the bottom of this one for a while.

Has it been covered before?

I have found the source - which I am sure others will know as an aperture with a grill (inch spacings) behind the glove box - only felt it with air blowing through so far- not looked yet. I managed to do this whilst we were driving over the top of the Pennines where the air is obviously pretty cold - so more of a problem than at street level.

Thoughts?

Should this vent exist?

Matt
User avatar
g8dhe
Supreme Being
Posts: 10766
Joined: Sun Apr 13, 2008 10:06 pm
Location: Worthing, West Sussex.

Re: Big Draft in passenger foot well

Post by g8dhe » Sat Mar 13, 2010 11:12 pm

Could be as simple as one of the control links has come off, they are fitted as shown in this thread http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=26835
Geoff
2001 Aero V6, AFT, full side conversion.
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: Big Draft in passenger foot well

Post by missfixit70 » Sat Mar 13, 2010 11:21 pm

Mattsonics wrote:Been meaning to get to the bottom of this one for a while.

Has it been covered before?

I have found the source - which I am sure others will know as an aperture with a grill (inch spacings) behind the glove box - only felt it with air blowing through so far- not looked yet. I managed to do this whilst we were driving over the top of the Pennines where the air is obviously pretty cold - so more of a problem than at street level.

Thoughts?

Should this vent exist?

Matt
Just like on the back of 61-B03 here - http://www.lushprojects.com/bongopartsm ... mgno=.html

It's part of the air intake, as Geoff says check all your controls & linkages are conected ok, if you put it to recirc see if it stops.

FAQ here that may help - http://www.igmaynard.co.uk/bongo/forum/ ... 43&t=28727
You can't polish a turd - but you can roll it in glitter.
Mattsonics

Re: Big Draught in passenger foot well

Post by Mattsonics » Sun Mar 14, 2010 6:57 pm

thanks

you were obviously correct!

for some dumb reason i had believed that the fresh air / recirculate controlled air fed solely into the heater matrix, which it obviously doesn't!

:oops:

so basically unless you want cold air in all the time - this stays shut!? i.e. this fresh air isn't warmed.

Matt
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: Big Draught in passenger foot well

Post by missfixit70 » Sun Mar 14, 2010 8:13 pm

Check your linkages & flaps are working ok, never been aware of draughts in the nether regions of my passengers :wink: & i don't often use the recirc control.
Do your heaters heat up ok?
You can't polish a turd - but you can roll it in glitter.
Mattsonics

Re: Big Draught in passenger foot well

Post by Mattsonics » Mon Mar 15, 2010 7:22 pm

Heater seems absolutely fine?

The recirculate control, controls a flap which is visible through the grill which seems to just open up to the outside world. would you expect the grill to be feeding into something else?

Maybe I am missing a part?


It can be quite cold in t' north!

Matt
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: Big Draught in passenger foot well

Post by missfixit70 » Mon Mar 15, 2010 7:26 pm

No that is how it's supposed to be , have a look on that lushprojects link.
You can't polish a turd - but you can roll it in glitter.
Mattsonics

Re: Big Draught in passenger foot well

Post by Mattsonics » Mon Mar 15, 2010 8:56 pm

Thanks Kirsty - I had a look at Lush Projects - it is actually very helpful!

I couldn't see any parts missing.

I do tend to drive about on the fells a lot - that probably has as much to do with it!

Cheers

Matt
Post Reply

Return to “Techie Stuff”