bodywork

[eckerB]

Does look like two parts to the wing going by the lushproject picture.Could do with some one who`s taken one off to confirm
it like you say.Cheers for that,much appreciated.

[You've Been Bongod]

the wing is 1 part not 2 parts

to take off open front door (bolts on inside ) 3 i think
under bonnet on top of wing
i cant remember if bumper has to be undone

hope this helps

ps contact japcarinports (ian taylor) in market drayton he will do the job for you

[Simon Jones]

Front wings are relatively easy to change, so my advice would be to find a replacement wing from a Bongo that is being broken. I know this is a passenger side wing, but £46 is good value compared to get the existing one repaired & sprayed:

http://cgi.ebay.co.uk/MAZDA-BONGO-NEAR- ... 20ada81df7

Give Bellhill a call & see if they can get you a drivers side wing to match.

[mister munkey]

That rusty seam is not part of a weld then?So if the wing was unbolted it comes in two parts
at this point where the rust is.

Nope.

It does for some reason look like its a seperate panel at the bottom end but not the case, its all part of the wing.

As already said though, a pretty cheap fix - short term.

[eckerB]

The wing is an offside wing,anyone know of one for sale?Will give Bell Hill garage a ring too.
Thanks everyone for you help,appreciated.Eric.

[jonah]

i've just had 2 complete rear arches fitted and a full respray (the rust damage was much worse than your photo!)
the guy that did is not a million miles away from you and a well respected Bongo man, sales,mechanics and bodywork.
Ian Taylor, Market Drayton.
highly reccomend his work, if it's good sound advice your after, he's the man.

[Alifriendee]

Bongonaught - roughly how much did that cost you? I need the same, well for me it's the inner and outer wheelarch panels rusted.