removing the front headlining

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Locked
User avatar
peanutcrusher
Tribal Elder
Posts: 546
Joined: Thu Feb 26, 2009 6:59 pm
Location: Portsmouth

removing the front headlining

Post by peanutcrusher » Mon Jun 29, 2009 11:18 am

I need to run so wires from my new sun visor which screens in them will I need to remove the headlining to do this or will work by just opening one end. is it easy to gain access behide the roof lining what is the best way to go about doing it. if it helps the wires from the screens goes up through the bolt that the visor fixes in place with.
Bongo now work later !!! :) :)
User avatar
missfixit70
Supreme Being
Posts: 12431
Joined: Fri Jun 01, 2007 3:53 pm
Location: weymouth

Re: removing the front headlining

Post by missfixit70 » Mon Jun 29, 2009 11:34 am

You shouldn't need to remove the headlining, undo the grab handle screws on the A-pillar, unclip the trim, undo the visor bolts & you should have enough access to run the wiring. If you do want to remove the headlining, I think it's only a matter of removing the scrivets at the rear of the headlining & the door rubbers to allow it to come out from that point.
You can't polish a turd - but you can roll it in glitter.
Locked

Return to “Techie Stuff”