Moderators: Doone, westonwarrior
to allow air to circulate from outside as opposed to from inside the vehicle.
Hmm, a common-ish fault, or a design feature? Mine seems to "wimp out" on the blowers if I shift it from full left, so I reckon it isn't functioning right. You might be right about the set up- perhaps the cable has stretched? Failing that, I did see an old post about wire connectors on the plastic ratchet that feeds from the dash heater controls- might be adrift one, but I don't know if the sliding control activates one of those in some way.brorabongo wrote:Mine does not go right across either. All I can think of is that the set up under the bonnet is'nt quite right? I have not bothered to check in detail, as it does work ok as far as I'm concerned.
Come to think about it, mines might of gone wrong at the same time I fixed my heater.dobby wrote:Mine does that as well, it's only done it since I fixed the heater though. I think I didn't re-fix the cable properly and pre-tensioned it. Next time the heater comes apart I'll fix it
Sounds like a cable then..possibly a case of taking out the dash inlay where the lever is and seeing what is(n't) attached- unless its just a matter of adjusting the tension at the other end by the air intake?brorabongo wrote:Come to think about it, mines might of gone wrong at the same time I fixed my heater.dobby wrote:Mine does that as well, it's only done it since I fixed the heater though. I think I didn't re-fix the cable properly and pre-tensioned it. Next time the heater comes apart I'll fix it
Looks like just a screw clamping the cable there-much like an old throttle cable adjustment- might have a mess with it this weekend.dobby wrote:it's definitely at the other end - air intake, for me
