Post
by stilldesperate » Fri May 29, 2009 10:25 pm
Most of the Bongo wiring seems to be well supported, and runs through the fuse box/s
Any wiring added later, as Dobby's picture suggests it prob is, is usually tacked-up with a few cable-ties (at best), or insulation tape, and can be prone to working loose.
If the horns have been removed, and the cables not tied back, then you will get loose wiring.
If everything else (electrics-wise) is working on the van, then it's a good bet that it's just for the horns, you might find the fuse has blown if dragging on the road has chafed through the wires.
Take it off if you don't need it, try reconnecting it if you do.
I wouldn't be too worried 'bout it.
SD
"The older I get, the faster I was"
