Air conditioning - solenoid not working

Technical questions and answers about the Mazda Bongo

Moderators: Doone, westonwarrior

Locked
splatt4001

Air conditioning - solenoid not working

Post by splatt4001 » Sun Apr 19, 2009 8:43 pm

Can anyone help? I press the AC button (blower fan is on); button lights up but nothing happens. Turns out that pressing the button does not trigger the clutch that is supposed to get the compressor working. AC belt is present and turning. Problem seems to be that the wire going to the compressor is not carrying any juice at all. Running 12v straight to compressor clutch DOES click in the AC. So question is: why might pressing the AC button not send the necessary volts to the compressor clutch? Any ideas?

Thanks.

Sam
steviebongo
Tribal Elder
Posts: 815
Joined: Thu Jan 08, 2009 8:55 pm
Location: glasgow

Re: Air conditioning - solenoid not working

Post by steviebongo » Sun Apr 19, 2009 8:54 pm

there could be a few thing's that could cause it ,the a/c system could be low in gas and that will stop the system from kicking in ,there is pressure sensors on a/c system if the system pressure is too low ie low in gas the it wont start the compressor,has ure a/c ever been serviced if not i would consider it ,my work charges aboot £90 for a system service ie regas and oil rechare,it will also identify any leaks if present. good luck.


cheers stevie
splatt4001

Re: Air conditioning - solenoid not working

Post by splatt4001 » Tue Apr 21, 2009 9:50 pm

Thanks. Sounds like everything's probably OK then. I will get it regassed and see if that does the job.
Sam
User avatar
mikexgough
Supreme Being
Posts: 6158
Joined: Mon Sep 08, 2008 9:02 pm
Location: Cambridgeshire - where the all the Slodgers reside
Contact:

Re: Air conditioning - solenoid not working

Post by mikexgough » Thu Apr 23, 2009 11:02 pm

You can test it by..... removing the dryer bottle terminal (it's on top) and link it across...... run the engine and switch on the A/C and bingo it should click in and run.....if it does.... regas is the most probable solution.....Air Con specialist or you could try an EZ-Cool aerosol to up jobby...(they do work)......should work on a Bongo too..
Conversant with Bongo Top Pinion Oil Seals

Bongo owning Velotech Cycle Mechanic
ramitin121

Re: Air conditioning - solenoid not working

Post by ramitin121 » Fri Apr 24, 2009 2:08 pm

splatt4001 wrote:Can anyone help? I press the AC button (blower fan is on); button lights up but nothing happens. Turns out that pressing the button does not trigger the clutch that is supposed to get the compressor working. AC belt is present and turning. Problem seems to be that the wire going to the compressor is not carrying any juice at all. Running 12v straight to compressor clutch DOES click in the AC. So question is: why might pressing the AC button not send the necessary volts to the compressor clutch? Any ideas?

Thanks.

Sam
my aircon was the same whould work with a 12volt feed. went to halfords and purchesed a can off aircon gas £35. and cliped it on the input line and it read low toped it up then the clutch come on every think fine. the gas has a leak sealer built in been working now for 9 month
try this hope it works
Locked

Return to “Techie Stuff”