
body damage
Moderators: Doone, westonwarrior
body damage
rear view mirror failure,result,crashed bongo ,smashed o/s rear light and bumper creased rear qtr panel
please tell it can be repaired dontwant to drive a mondeo for life

Re: body damage
Hi dave badluck fella, if it any consilation my rear nearside 1/4 was creased from top of light to top of rear side window and along as far as the sliding door, it was un pullable and needed a new panel about 380 odd quid from memory for the panel alone
light was from club shop, mine was swiped by a lorry when my outlaws borrowed it 3 weeks after i got it
the total bill for repairs was £1300 odd which i did not pay for
dont forget the offside panel is considerably bigger tho
goodluck with it hope it can be pulled out and sorted it will depend alot on how bad it is, has the crease breached the roof line
the place i went to chopped the new panel so it didn't go into the roofline said he didn't want to go there
Dar







Dar
All disclaimers count as i know nothing
BUY A V6er i like my affair with the petrol pump
BUY A V6er i like my affair with the petrol pump
-
- Supreme Being
- Posts: 3945
- Joined: Sat Jan 13, 2007 10:12 pm
- Location: Scottish Borders
Re: body damage
Location, Location, Location and photos of the damage please. Rear light clusters and rear bumpers are available on ebay and from spare parts suppliers who support this website. Depends really on how bad is the damage to the side pannel, people have repaired slight bumper damage themselves. If you are near Wigan bigdaddycain can put you onto the bodyshop that Wheelquwick use.
Tony
Tony
Former SGL5 Owner Jeep Cherokee 2.5CRD Burstner Ixeo Time it585
Re: body damage
thanks tony and dar i live in hope 

- mikeonb4c
- Supreme Being
- Posts: 22877
- Joined: Sun Nov 05, 2006 10:49 pm
- Location: Living with Mango Bongo in the North West but with a tendency to roam
- Contact:
Re: body damage
Is that Hope, Derbyshiredave.h wrote:thanks tony and dar i live in hope



Welcome dave.h. I crunched my bumper and managed to get it looking really good with hot air gun, bunched cloths as dolly's etc. then resprayed it. It can (sometimes) be done as the plastic is amazingly compliant (I even welded the split in it using some spare bumper material (from foglight cutouts) as 'solder', and with hot air gun and putty knife, wet n drying it all down afterwards.
Re: body damage
Hopefully it won't be too bad.... I've got a similar situation at the moment due to a bit of carelessness on my part!
Anyway, I got the bumper back into shape by heating it up with a hairdryer and pushing the dent from the back. Pity I can't use the same technique on the rear panel!!
Phil
Anyway, I got the bumper back into shape by heating it up with a hairdryer and pushing the dent from the back. Pity I can't use the same technique on the rear panel!!
Phil