Ignition switch wiring

The Great Pretender · Post by **The Great Pretender** » Tue Jan 08, 2008 11:21 pm

Fitting an alarm and need to know what colour wires go from the switch to the starter and stop valve if anyone can help.

roosteruk · Post by **roosteruk** » Tue Jan 08, 2008 11:24 pm

I am fitting an alarm saturday and need to find that too.
I aim to find the ignition connector and then maybe chase the wiring from there

The Great Pretender · Post by **The Great Pretender** » Tue Jan 08, 2008 11:29 pm

roosteruk wrote:I am fitting an alarm saturday and need to find that too.
I aim to find the ignition connector and then maybe chase the wiring from there

Did you go for the Hawk alarm?

roosteruk · Post by **roosteruk** » Tue Jan 08, 2008 11:33 pm

I did, but it aint mine I am fitting.
Its Bongoinmad 1st, then Platty, then I may find time to slot Roosters in...????lol

stringman · Post by **stringman** » Wed Jan 09, 2008 12:13 am

You need to check this with a test light or multi meter:

Starter crank at ignition switch: 2.0mm black/ yellow wire

Engine stop: At fuse box behind fuse 9 1.5 mm Black/white or black/ yellow wire.

indicatoer if you need those: in block connector O/S kick panel green/black and green/white wires

Good luck

cheffy34 · Post by **cheffy34** » Wed Jan 09, 2008 12:24 am

Watching this one with great interest, ordered mine today, havent decided if im brave enough to tackle it or pay someone

The Great Pretender · Post by **The Great Pretender** » Wed Jan 09, 2008 12:43 am

Thanks Stringman will use my meter. The reason for asking is that I have a problem with arthritus so the least time I spend in awkward positions the better.