Front diff again
Moderators: Doone, westonwarrior
-
- Apprentice Bongonaut
- Posts: 8
- Joined: Mon Nov 26, 2007 10:59 am
- Location: Newport Gwent
Front diff again
Earlier this year I had to replace the front diff on my '96 SGLR when the whining noise finally became more than I could bear. I replaced it with another one from a broken Bongo which included a 30-day warranty. 10 months and about 7000 miles later problems have started again. This time it's not so much a whine but a rumble at low speeds up to 30 and then more even bearing noise up to 60. The o/s front tyre also seems to be making slapping noisesas it goes round. I've taken the vehicle to 2 garages for inspection, one a Bongo-friendly in south Wales and the other my local one who replaced the diff 10 months ago. Both say it's the front diff again. Rather than get another used one, I'm wondering if it's possible to rebuild the one I've got and if so, where. Has anyone gone down this road before? I've been quoted 800 quid for a new diff from Mazda which I really don't want to spend on such an expensive Christmas present for the Bongo, much as I love/hate the darn thing. Would be grateful for any help/advice/sympathy.
-
- Supreme Being
- Posts: 10637
- Joined: Fri May 13, 2005 11:58 am
- Location: Ince Lancs
If you still have the old one I would look to rebuild that. If the teeth on the crown wheel and pinion are OK then its just a matter of shims and bearings. The high pitched noise the old one made suggests it may just be the bearings. The bearings can come from any factor at reasonable prices. The only tricky bit is setting up the pinion endfloat but it's not that hard.
If the teeth are worn then the price will mount up because you will probably have to get them from mazda.
If the teeth are worn then the price will mount up because you will probably have to get them from mazda.
- dandywarhol
- Supreme Being
- Posts: 5446
- Joined: Mon Dec 19, 2005 10:18 pm
- Location: Edinburgh
- missfixit70
- Supreme Being
- Posts: 12431
- Joined: Fri Jun 01, 2007 3:53 pm
- Location: weymouth
- dandywarhol
- Supreme Being
- Posts: 5446
- Joined: Mon Dec 19, 2005 10:18 pm
- Location: Edinburgh
You're right Kirsty - that can cause it if it's outwith the recommended spec (whatever that ismissfixit70 wrote:Not being an expert or anything, but it's not down to incorrect tyre sizes & the wind up effect on a 4wd is it?

Whale oil beef hooked
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Frot diff
Last year I broke the front diff on my 4WD Bongo when I first bought it.
To cut a long story short it was to do with different size tyres, front were road tyres, rear were snow tyres, this is how it came over from Japan apparently.
These had a different rolling radius and caused a whirring noise from the front end. It also caused to autobox to get hot and there was a smell of hydraulic fluid.
Had the front diff changed by a garage in Gorseinon, no problem since. Replacement diff has been on the Bongo since Oct 06 (13 months ago).
To cut a long story short it was to do with different size tyres, front were road tyres, rear were snow tyres, this is how it came over from Japan apparently.
These had a different rolling radius and caused a whirring noise from the front end. It also caused to autobox to get hot and there was a smell of hydraulic fluid.
Had the front diff changed by a garage in Gorseinon, no problem since. Replacement diff has been on the Bongo since Oct 06 (13 months ago).
-
- Supreme Being
- Posts: 10637
- Joined: Fri May 13, 2005 11:58 am
- Location: Ince Lancs
I think dandy could confirm that mismatched tyres and a 4wd bongo would need to travel on an old roman road in an arrow straight line for quite a few miles for the diff to become slack enough for them to wind up again...That's if my limited (slip diffmissfixit70 wrote:Not being an expert or anything, but it's not down to incorrect tyre sizes & the wind up effect on a 4wd is it?

ビッグダディケイン RIP Big Bank Hank (Imp the Dimp) 1957-2014