Bongo Fury

First time poster as not had any problems in the last 3 years.
Have looked through all comments about the flashing hold light error.
I am not technically inclined and all information has been supplied by my Bongo specialist garage from the Newbury area.
I have a flashing hold light that does not seem to affect the bongo that myself or the garage can detect, although it could be burning more fuel than usual. The garage had a diagnostic test and we have following fault code of PO743 indicating a Solenoid. "Torque eon Clutch Solenoid valve". as shown in the following diagram (link).
My question is, would anyone know the correct part number from the diagram below.

BW01-21-1D1 or BW01-21-1D2. Go to web site called partsouq ond select mazda then scroll down to bongo then select freindee. It will be in 4-Cylinder - Engine & Transmission or V6 Engine & Transmission depending on which engine you have then go to the file with control valve.
You can order it direct from that site and will cost about 58 dollarsor 42 quid delivered.

wonderful website used them a couple of times already

knpenny wrote: Fri Apr 06, 2018 10:31 pm BW01-21-1D1 or BW01-21-1D2. Go to web site called partsouq ond select mazda then scroll down to bongo then select freindee. It will be in 4-Cylinder - Engine & Transmission or V6 Engine & Transmission depending on which engine you have then go to the file with control valve.
You can order it direct from that site and will cost about 58 dollarsor 42 quid delivered.

wonderful website used them a couple of times already

Very interesting site.

did you get the part you were looking for?