Page 1 of 1

OEM Aerial fitment

Posted: Wed Feb 08, 2017 4:51 pm
by e31shrew
Hi all
We have a 98 Bongo and wondering if anyone knows how to replace the aerial? Assume the plastic cap in the centre comes out but have used a sharp knife, and besides losing three fingers, it doesn't want to budge!
Any assistance gratefully received
All the best
Steve

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 5:20 pm
by Bongolia
best of my recollection its secured by two screws either side. The centre remains untouched. They may be covered by little plastic covers, get :D them out with the edge of a stanley blade. Mind your fingers though. :D

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 5:35 pm
by Bob
I've a good idea there is a 'Fact Sheet' on this. :wink:

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 5:52 pm
by e31shrew
Thanks chaps. There is indeed a couple of screws either side. I'll hunt for A fact sheet first then give the other option a bash.
Thanks again

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 6:05 pm
by Bob
Members' area, second one down.

To get the said area you need to click on the 3 horizontal bars, top left of main page, just under 2Gether insurance ad. 8)

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 6:09 pm
by e31shrew
Got it. Thanks Bob. Looks like the small cap needs to be prised off and then use all six hands to catch a ball bearing as well as other bits and bobs

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 7:44 pm
by Northern Bongolow
there is a small spring to catch too. use yer teeth to catch this. then when you have it in bits you will NEVER work out how it goes back together to get the 2 clicks to work correctly. ive done several and still would rather not.

top tip when putting it together use a bit of grease or vaseline, but i cannot tell you where for. :shock: :lol:

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 10:23 pm
by e31shrew
Ooooer matron! Thanks again

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 11:20 pm
by Merlot man
It's good advice to read the fact sheet and no need to remove the two side screws only the middle one but as northern bongolow said there is a spring and ball bearing that needs to be put back in place , if you loose them your goosed !
Best of luck
Brian

Re: OEM Aerial fitment

Posted: Wed Feb 08, 2017 11:33 pm
by Bob
Merlot man wrote:It's good advice to read the fact sheet and no need to remove the two side screws only the middle one but as northern bongolow said there is a spring and ball bearing that needs to be put back in place , if you loose them your goosed !
Best of luck
Brian

That's why you need Vasseline.

I'll get me coat. :lol: