Service Manual Query..
Posted: Mon Jun 23, 2014 9:20 pm
I have a well used WL-T Service Manual and I wondered if someone could check whether newly purchased manuals have a correction for the following..
Page 92 - Service Code 12 - Throttle Sensor Signal System
Inspection Point 4 Procedure says Check Connector B to ECU 2k (for Manual Vehicles) and ECU 2A (for automatic vehicles).
I think the ECU terminals are the wrong way around as for Manual Vehicles ECU 2K is Idle Switch (but 2A is Constant Voltage Power - Throttle Sensor/EGR Position Sensor) and for Automatics ECU 2A is an Earth (but 2K is Constant Voltage Eletric - Throttle Sensor/EGR Position Sensor)
So assuming my manuals pinouts are correct, I think the manuals procedure should have been 2A for Manuals and 2K for automatics..
cheers,
Ant.
Page 92 - Service Code 12 - Throttle Sensor Signal System
Inspection Point 4 Procedure says Check Connector B to ECU 2k (for Manual Vehicles) and ECU 2A (for automatic vehicles).
I think the ECU terminals are the wrong way around as for Manual Vehicles ECU 2K is Idle Switch (but 2A is Constant Voltage Power - Throttle Sensor/EGR Position Sensor) and for Automatics ECU 2A is an Earth (but 2K is Constant Voltage Eletric - Throttle Sensor/EGR Position Sensor)
So assuming my manuals pinouts are correct, I think the manuals procedure should have been 2A for Manuals and 2K for automatics..
cheers,
Ant.