Bongo Fury

I know this has been discussed before but can't find it. As much as I love my van I have had enough of the beeping when I have the key in the ignition and the door open. I have had the panel to the right of my right leg off today in the hope of disconnecting the beeper. However, there are a number of connectors and wires in there! Can anyone tell me which one I have to disconnect please?

You just need to unclip this connector;

Under the cowl below the steering wheel, with care you don't need to remove the cowling.

OK thanks, but I was told by a couple of people it was behind the trim on the right hand side of the drivers footwell. Is it the same on all Bongos? Mines a 97 model.

No the Sound Warning System module is down there, many people cut the wires, for the Key-in-lock signal all you need do is separate the connector shown and the door beep will stop, Headlights, AFT and reversing beeps won't be affected.

OK thanks I'll give it a go and report back.

SORTED!!!! Silence is truly golden. Thanks for the advice.

Thank. We did this too. What a difference it makes!

Its much nicer than cutting the wires or sticking a screwdriver thru the buzzer that others have done, and if you want, it can always be put back to standard!