Page 1 of 1
Wont run for long after fuel filter change
Posted: Fri Mar 21, 2014 2:45 pm
by Dodgey
I changed the fuel filter and check the banjo. Now, she starts and runs for a short while - lump. Then dies completely and requires about 10 seconds of cranking to get going again. Only to repeat the same over and over. She'll sit ticking over, but when I rev her, after 20 or so seconds - dead again. Any idea?
Re: Wont run for long after fuel filter change
Posted: Fri Mar 21, 2014 2:48 pm
by Simon Jones
Clean the banjo filter again as it's possible new filter has some loose bits from the element which have washed downstream to the injector pump. Did both copper washers go back on the banjo so there is an airtight seal?
Re: Wont run for long after fuel filter change
Posted: Fri Mar 21, 2014 2:50 pm
by Dodgey
There were washers between the female fixing and the engine. They stayed in place. I'll go check the banjo again now....
It will tick over seemingly forever, as soon as I rev her - she complies, then dies shortly afterwards.
Will report back in a sec...
Re: Wont run for long after fuel filter change
Posted: Fri Mar 21, 2014 2:58 pm
by Dodgey
Washers are where they should be (one under the bolt head, one under the round female fixing), banjo clean. I'm starting to consider putting the old fuel filter back on..... I only changed it as a service item
Re: Wont run for long after fuel filter change
Posted: Fri Mar 21, 2014 3:23 pm
by Dodgey
Got it - didn't replace the bottom rubber "o" ring below the fuel filter - between it and the white plastic float holder
Re: Wont run for long after fuel filter change
Posted: Sat Mar 22, 2014 12:24 pm
by Simon Jones
That would make sense as the pump would be sucking in air rather than diesel. Glad you got it sorted.
Re: Wont run for long after fuel filter change
Posted: Mon Mar 24, 2014 3:47 pm
by Dodgey
Yeah - had me well confused. Out of interest - why does fuel starvation cause clouds of smoke?
Re: Wont run for long after fuel filter change
Posted: Mon Mar 24, 2014 4:31 pm
by Simon Jones
Don't know for sure. On my XC70, I was getting loads of black smoke when the intercooler blew which resulted in incorrect air/fuel mixture. Popped a new I/C in (no mean feat when its sandwiched between the air con & cooling radiators) & problem went away.

Re: Wont run for long after fuel filter change
Posted: Mon Mar 31, 2014 3:52 pm
by Dodgey
... bet you left one of those screw drivers in there....

Re: Wont run for long after fuel filter change
Posted: Tue Apr 01, 2014 7:29 pm
by Simon Jones
No, but I did have a few bolts left over

Re: Wont run for long after fuel filter change
Posted: Tue Apr 01, 2014 10:38 pm
by Dodgey
lol
