Page 1 of 1

rear heater

Posted: Mon May 07, 2012 11:33 am
by Bongolitus
My 1998 4WD 2.5 TD Bongo is needing a new bit.. it's the pipe that feeds the rear heater..not sure of its technical name but it comes out the engine, heads towards the back..there's a T junction in it as well.. Sorry to be so vague but if anybody can help with proper name of part or even part number that would be grande..

Re: rear heater

Posted: Mon May 07, 2012 12:05 pm
by jaylee
See anything you recognise on here....? http://lushprojects.com/bongopartsmk2/c ... mgno=.html

Re: rear heater

Posted: Mon May 07, 2012 12:19 pm
by Bongolitus
Thanks Jaylee.. I'll show this to my mechanic..I'm sure it will be of great help.. thanks again

Re: rear heater

Posted: Mon May 07, 2012 12:28 pm
by jaylee
You description sounds like it could be part 61-2D1...? It's a metal pipe with a tee piece in it, under the drivers seat, but closer to the sill...?

Re: rear heater

Posted: Mon May 07, 2012 12:36 pm
by Bongolitus
Thats the one..many thanks... this just shows the benefits of joining the club..cheers

Re: rear heater

Posted: Mon May 07, 2012 12:41 pm
by jaylee
Did your mechanic mention whether the metal pipe had a leak due to corrosion, or is it the rubber hose connecting it up?? [-o<

Re: rear heater

Posted: Mon May 07, 2012 3:10 pm
by Simon Jones
They are quite tricky to get hold of new. I know where there is a second hand one, but it may not be in much better condition than yours.

Re: rear heater

Posted: Mon May 07, 2012 4:33 pm
by Bongolitus
He reckoned it was the pipe.. :(

Re: rear heater

Posted: Mon May 07, 2012 9:05 pm
by Bongo??
Simon Jones wrote:They are quite tricky to get hold of new. I know where there is a second hand one, but it may not be in much better condition than yours.
Hi. I`ve just recently fitted a new one of these pipes,genuine Mazda part,no.S09A-61-22YA.
This is the metal pipe that goes from the front heater,has a tee to the engine block and then to a rubber hose to feed the rear heater.
My Bongo`s a V6 but i believe the pipes the same on all models.......
I got mine from Bongobits,but be warned,you don`t get much change out of £90 and i had to wait just over 3 weeks for it even though i was told a couple of days.
You could feed 16mm rubber hose in place of the metal pipe,connecting using tee pieces and straight connectors,good bit cheaper n`all :wink:

Re: rear heater

Posted: Wed May 09, 2012 8:07 pm
by Bongolitus
Thanks Simon..I'll have a word with mechanic to make sure..but I'm pretty certain we're on the right track now.. Thanks again

Re: rear heater

Posted: Mon May 21, 2012 5:36 pm
by corrour
I had the same and replaced mine with 16mm rubber heater hose from the front with a T piece at the back .
Never had any problems
Now taken leaking rear heater out ard replaced the one that goes across to N/S as that started leaking when i removed heater pipe. Its not to bad a job n saves you loads. :D