Bongo Fury

Anyone know what size dust covers i need for track rod ends and ball joints please and the best place to get em cos i need to get ahead for my MOT


cheers in advance

Dar

Hi Dar, i'm gonna keep a close eye on this thread because i got an advisory on these, the MOT just gone..

If you find them on Lushprojects, post the part number on here, then I'll investigate.

i will measure for you tomorrow if i dont forget . i have both the bits as spares so i will get the callipers out.

cheffy34 wrote:Anyone know what size dust covers i need for track rod ends and ball joints please and the best place to get em cos i need to get ahead for my MOT


cheers in advance

Dar

Hi once Ady has measured them you can get them from e bay.

Here are some,

http://compare.ebay.co.uk/like/17080069 ... adtype=pla

ive bought the ones similar to the ones in teenmal's link for the ball joint, but i dont think they will work/last too well.
the bottom rubber to metal seal on the ball joint has a metal gripping band around it/in it, as part of the rubber boot to secure it to the joint.
i checked the trackrod end boot and the front droplink boot and they are all the same.
all the parts i checked are gen mazda parts, others may be different.

sorry for the delay i will measure/ picture, all three boots for the ball joint, front droplink, and trackrod end shortly, and get the boss to post them up.
i feel a fact sheet coming on,

hope the following link helps the search for replacement rubbers

http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=54672

Thanks guys muchly apreciated,

A fact sheet is a good idea i finx.

You can practice on mine if ya like save me the bother , keep the info coming


Dar