Bongo Fury

Hi guys need a bit of your advice of late my roof wont go to its stop position it goes all the way to the top but wont stop bleeping untill i give it the extra shuv to the last inch or so then bleep stops,, is ther anything that needs adjusting to reset the stop position? many thanks barrington,

Join the club loads of us have the same problem its just a small inconvenience.

Try unzipping the tent front a little before you lower it. It helps to expel the air, but it also means that there's a slightly less strain when you open it next time.

A bit of lube on the moving bits may help too.

so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

Barrington wrote:so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

It's the weight of all that "BLING" holding it down

tent fabric being stiff after a long cold winter? mechanism needs lubing therefore a bit more friction for the motors to overcome? motors getting a bit older?

missfixit70 wrote:A bit of lube on the moving bits may help too.

Tried that made mine even stiffer

bongobaz wrote:

missfixit70 wrote:A bit of lube on the moving bits may help too.

Tried that made mine even stiffer

Baz what you like

I know . i've just finished work too

Try a bit ot this



In the runners & rams a couple of times a year.

Works for me.

dandemann8 wrote:

Barrington wrote:so guys what actually causes it?, its only just started doing it, is there any over run on the runners i can adjust,

It's the weight of all that "BLING" holding it down

Ok chris thanks mate will give it a shot, so nothing to adjust then?

I.m sure technical adjustments are available but in the early stages of Middle Aged Sticky Roof Syndrome the spray works for me,

Barrington wrote:Ok chris thanks mate will give it a shot, so nothing to adjust then?

I think one or two have found a microswitch has moved slightly? A search may find an answer