Bongo Fury

Hi all,

I've read a few threads and looked on the Alloys factsheet and got myself some Mitsubishi 16" alloys off ebay.. I was just looking up the loading recomendations against the tyres that are already on the alloys and they're not enough - was going to get some decent boots as recommended in various posts..

BUT: I just found a few posts stating concerns over people using car wheels on Bongo's - it seems to me that most Bongo's use car alloys - in practicality is this really an issue (I did see the post on insurance claims & non-van rated alloys tho)?

I'm now considering not using them - am I being too alarmist? A lot of Bongos seem to use RX8 alloys, which is lighter than the Galant/Lancer my ones came off. Mines a 2wd AFT and will never be loaded upto the gills like a van. I might get some earache off the wife, but the alloys will also fit the Primera I'm buying (and its got good car tyres on it so all is not lost).

cheers,

Steve

think you answered your own question there

as you will have another motor to use them on

why not get the correct rating as they are not going to waste

As Wonka says, if you're asking the question, you probably know the answer Do they have a load rating on them?
This thread is the most recent discussion - http://www.igmaynard.co.uk/bongo/forum/ ... ng#p394324

..yes, was afraid I knew the answer..

However, I've been doing a bit of research on Autotrader and it appears the alloys I've got were original fit on an Mitsubishi Outlander which is a big 4x4 SUV thingy that grosses as 2t unladen- which I think means the load rating should be fine (and a much better bet than RX8 alloys etc).

Was in a bit of a rush as I want new tyres before taking the Bongo out on its Easter holidays!

Phew !