Bongo Fury

Have just removed my airbag steering wheel and now (obviously) the airbag light is flashing constantly, as if I didn't realise I no longer have an airbag which is sitting in my garage!
Any thoughts on how to stop it?

I thought:
1. Remove the bulb - how fiddly a job?
2. Wait until the bulb goes - could be a while but it is flashing constantly rather than coming on briefly at startup!
3. Permanent marker pen over the light!
4. Live with it as it's not actually in my line of sight and not bothering me that much - yet!

Andrew

if you disconect the battery it resets the computer, and it might disable the light flashing?, worth a try

waycar8 wrote:if you disconect the battery it resets the computer, and it might disable the light flashing?, worth a try

I'll have to disconnect the battery to have another go at getting the horn to work so will see then.

Cheers

Andrew

BDC had a tip a while back for fooling the system into thinking the airbag was still there..

On page 2 of this thread.


http://www.igmaynard.co.uk/bongo/forum/ ... ag#p252914

Get it sorted before MOT time though, they won't like that flashing light.

Didn't you get the instructions with the new steering wheel about soldering a resistor across the airbag terminals? If not, it may be worth contacting the seller? May help with your horn problem too? The instructions I got with mine were for an airbag model & therefor useless to me, but they did provide a resistor with it though, so the info should have been with it. Can't find mine unfortunately.

missfixit70 wrote:Didn't you get the instructions with the new steering wheel about soldering a resistor across the airbag terminals? If not, it may be worth contacting the seller? May help with your horn problem too? The instructions I got with mine were for an airbag model & therefor useless to me, but they did provide a resistor with it though, so the info should have been with it. Can't find mine unfortunately.

I can't remember having any further instructions or a resistor with mine.
Will e-mail him now!

Thanks

Andrew

The only help i can offer is, i can take the bulb out when i put your white dials in.

mister munkey wrote:BDC had a tip a while back for fooling the system into thinking the airbag was still there..

On page 2 of this thread.


http://www.igmaynard.co.uk/bongo/forum/ ... ag#p252914

Get it sorted before MOT time though, they won't like that flashing light.

Errr,

Hello??

daveblueozzie wrote:The only help i can offer is, i can take the bulb out when i put your white dials in.

That would be good - will this matter in an MOT do you think? A light that doesn't flash?

Andrew

mister munkey wrote:

mister munkey wrote:BDC had a tip a while back for fooling the system into thinking the airbag was still there..

On page 2 of this thread.


http://www.igmaynard.co.uk/bongo/forum/ ... ag#p252914

Get it sorted before MOT time though, they won't like that flashing light.

Errr,

Hello??

Hello? was that aimed at me - did I miss something?

Andrew

hembramacho wrote:

daveblueozzie wrote:The only help i can offer is, i can take the bulb out when i put your white dials in.

That would be good - will this matter in an MOT do you think? A light that doesn't flash?

Andrew

I think it might.

Errrr . . .

Hello??

mister munkey wrote: Get it sorted before MOT time though, they won't like that flashing light.

Confused here!
Sorry if I've upset someone, but not sure what I've said?
Reading back over the post, is an MOT failure the same if you've got a light flashing AND if you have a light that's there but not flashing?
Please, someone put me straight.

Andrew

ps whoever I've upset please also put me straight!

I think both, if it's flashing it'll be a fail & if it's supposed to have the light on startup & it doesn't it may fail, not an expert on that though, I'm sure someone'll be along with a definitve answer. Hence the mod as described by BDC in MM's link, or fitting the resistor which I think simulates the airbag being there.
The other think to make sure of is that you've informed your insurance company.

Still confused about previous posts!