Page 1 of 1
light out
Posted: Fri Apr 10, 2009 10:43 pm
by peanutcrusher
my new bongo has a light out on the dash.
i have two switches for the blinds and one on them the bulb has gone, is it easy to replace, how do i do it.
Re: light out
Posted: Sun Apr 12, 2009 1:30 am
by brorabongo
One of my blinds switch light plays up now and again, when it goes off a gentle tap has up to now fixed it.
Re: light out
Posted: Sun Apr 12, 2009 6:55 am
by jaylee
Hi, remove the switch & you should immediately see the back of the bulb holder on the side of said unit..
The holder could just be making bad contact on the PCB, just remove the bulb holder (a bit fiddly) very gently prise the wire that comes out of the bulb & wraps round the holder out of it's groove slightly with a thin blade implement so it's more inclined to make the contact & refit.
Of course, if that don't work the bulb could be duff.
Also while the switch is out (& connected up) check the PCB contact with the bulb out with a multimeter while the side lights are on.. (just to make sure the connections OK on the loom.)
