Bongo Fury

hi had a hold moment this evening .

stopped at a junction hold light came on and stayed on. Also noticed temp had dropped to eleven o clock position mason didnt alarm when i turned setting down as it usually does. think its all down to my fitting the mason last sat.

pulled over and when i restarted all back to normal

have rechecked screws and four behind speedo

i think its something i loosened when fitting mason.

Any advice or opinions please .

Don't know, but could you have accidentaly touched the Hold switch? I've done this.

thanks bob may have gone to gear down not sure tho. but the temp going back to 11 oclock and mason not working then makes me wonder if i broke/ loosened something in there light stayed on until i turned off engine. Probaly am a bit paronoid still getting used to bongo