Page 1 of 2

Elivating Roof Problems

Posted: Fri Jun 13, 2008 8:56 pm
by patrick
has anybody had a problem with the elevating roof? When i raise my roof it makes quite a groaning noise and as it gets higher it starts to judder quite badly. I took it to the garage from where i bought it and they sprayed it with w.d.40 but it has not cured the problem. I wondered if there was one or maybe two motors to raise the roof and if so where do they live. If there are two I thought one may have packed up and as it is still under warranty I could get it sorted. The garage are very good in general but if I could go with a bit of knowledge up my sleeve it may help.. So anybody got any ideas.please.
Regards Patrick

Re: Elivating Roof Problems

Posted: Fri Jun 13, 2008 8:59 pm
by westonwarrior
mine does the same I have sprayed grease everywhere i can see but still judders

a couple of weeks ago on a weekend away having raised and lowered a few times to drive away it stopped

but came back :(

Would be interested to see if some one has cured this

Re: Elivating Roof Problems

Posted: Fri Jun 13, 2008 9:19 pm
by haydn callow
Give the strut rods and all the guide channels a good clean with white sprite. Then get a spray can of "white grease"(lithiham) from Halfords. Give everything a careful spray.
Always have the engine running when opening the roof....next time it is up....unzip the canvas sides and roll/ velcro them up....this makes it much easier for the motors to operate.
Should now be o.k. when you have operated the roof a few times.

Re: Elivating Roof Problems

Posted: Fri Jun 13, 2008 9:40 pm
by AndAndDen
Agree with Haydn :wink: We keep our canvas sides un zipped seems to solve the problem :wink:

Re: Elivating Roof Problems

Posted: Sat Jun 14, 2008 8:20 pm
by patrick
Thanks to hayden and others for the advice I am going to France tomorrow for a month and wont be using the roof whilst away but as soon as I return I will try your suggestions and let you know the result thanks again for your advice,

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 10:37 pm
by apole
Hi,

Haydn is correct. Also when you are doing the cleaning/regreasing, look carefully at how it all works, there is more than one channel on each side with rollers etc on it, make sure you do them all on both sides.

Andy

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 10:50 pm
by thedogsbollox
haydn callow wrote:Give the strut rods and all the guide channels a good clean with white sprite. Then get a spray can of "white grease"(lithiham) from Halfords. Give everything a careful spray.
Always have the engine running when opening the roof....next time it is up....unzip the canvas sides and roll/ velcro them up....this makes it much easier for the motors to operate.
Should now be o.k. when you have operated the roof a few times.
Sorry Haydn, i had to point this out
Use white spirit to clean the parts. The fizzy stuff in the can will be no use at all and will only make things sticky, which will make the situation worse :D :D

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 10:55 pm
by missfixit70
ROFL, I'd missed that one :lol: :lol:

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 11:05 pm
by haydn callow
I find the spray cans of white grease really good.

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 11:07 pm
by missfixit70
haydn callow wrote:Give the strut rods and all the guide channels a good clean with white sprite

Re: Elivating Roof Problems

Posted: Sun Jun 15, 2008 11:24 pm
by haydn callow
O' right, o.k., yep, got it, fine, I was just keeping in the sprite of the Elivating Roof Problems.
Phew !!! got out of that one !!

Re: Elivating Roof Problems

Posted: Mon Jun 16, 2008 12:32 am
by thedogsbollox
haydn callow wrote:O' right, o.k., yep, got it, fine, I was just keeping in the sprite of the Elivating Roof Problems.
Phew !!! got out of that one !!
well done, cos you were diggin yerself in deeper there for a mo.
See ya at the bash
Tony

Re: Elivating Roof Problems

Posted: Mon Jun 16, 2008 1:07 pm
by Ralph
A good clean of the struts and a spray with a silicone
based polish helped ours no end, also undoing the zips.

Re: Elivating Roof Problems

Posted: Mon Jun 16, 2008 6:16 pm
by Bin Bongoed
On the subject of elevating roofs, my roof alarm is now peeping the whole time the engine is running. The only time it stops is when it is fully erected (careful).

When lowered, it seems to lock correctly (at least from the sound, it seems to click in as it did previously). I've raised and lowered it a number of times, no change. We did connect with a branch in the narrow Devon lanes, and there is a little daylight showing where the tent joins the roof on the top left corner, but everything else seems OK.

Any ideas, anyone?

Re: Elivating Roof Problems

Posted: Mon Jun 16, 2008 6:30 pm
by haydn callow
Sounds as though the micro switch is not being compressed enough.
Get up on a step ladder and you will find the switch. Bend it up a bit or put a sticky pad on the roof seal so it presses the switch.