Page 1 of 1
Heater Control Face Lighting
Posted: Mon Feb 18, 2008 9:19 pm
by lochan2
Just realised that I can only see the lower half of my heater control unit, not the red/blue temperature bar. I'm sure it used to light up too !? What does yours do, and if it lights up does anyone know how to get to the bulb and what bulb is needed please
Posted: Mon Feb 18, 2008 9:47 pm
by daveblueozzie
yes me too please ,but i can only see the top section not the bottom.
Posted: Mon Feb 18, 2008 9:54 pm
by ford tinny
Hello, i think this has been covered before try this link
http://www.igmaynard.co.uk/bongo/forum/ ... hp?t=16703
John
Posted: Mon Feb 18, 2008 9:59 pm
by heatherpetch
Me too
Posted: Mon Feb 18, 2008 10:19 pm
by missfixit70
I think the temperature control unit (manual heater controls) is different to the climate control unit (digital controls), so I don't know how useful that thread will be
Posted: Mon Feb 18, 2008 10:26 pm
by ford tinny
Sorry folks
I must pay more attention in class
John
Posted: Mon Feb 18, 2008 10:29 pm
by missfixit70
Can you help it if you're so keen to help?
Write out 100 times "I must pay more attention to the question"
I'm surprised BDC hasn't had a white facia made up for his yet
Posted: Tue Feb 19, 2008 7:52 pm
by Rhod
I had/have the same problem.
Illumination is provided by 3 bulbs - 1 top, 1 bottom & 1 for the heater speed switch. To access them you need to first disconnect the bowden cables linking the lever on the control panel to the control flaps. There are 2 of these. The one controlling the vent position (demist/feet/face etc) is on the lefthandside of the passenger footwell. The one controlling fresh/recycled air is under the bonnet, on the edge of the plastic ducting above the heater fan. Once you've disconnected these, use a pair of radio removal tools (the u-shaped metal ones, or ones you've made out of a coat-hanger
) - insert them in the pairs of holes either side of the control unit & pull it out. You'll find the bulbs fairly obviously now. In my case it was a poor connection with the bulbs rather than the bulbs themselves at fault, so I'm not sure what size of bulbs you'll need. When you put it back together you need to make sure that the outer casing of the recycle/fresh air control cable is clipped in the correct position, or you might find the lever creeping to the "recycle" position all the time
I've lost illumination to the red/blue control again & the speed switch sometimes needs a technical tap to get it to light up, so guess I need to get back in there again. If you find out what the bulb size is please post it
Rhod
Posted: Tue Feb 19, 2008 7:55 pm
by bigdaddycain
missfixit70 wrote:
I'm surprised BDC hasn't had a white facia made up for his yet
Hmm.....
Posted: Tue Feb 19, 2008 8:09 pm
by lochan2
Thanks Rhod....
guess I'll wait til its a bit warmer and the days a bit longer!
Posted: Tue Feb 19, 2008 8:26 pm
by Rhod
It's not a difficult or long job Lochan- I did it in the dark! Only outside bit is 30 second job to locate & disconnect the cable under the bonnet. Don't be put off by my long description!
Rhod
Posted: Tue Feb 19, 2008 8:55 pm
by sajseven
Post pictures before, during & after! Please?
