Page 1 of 1
how can i get the heater fan switch out of the dash,
Posted: Mon Jun 04, 2007 10:25 pm
by berniehoo
i,ve poked a screwdriver in the 4 holes and relesed the clips, but can only move it forward about 1 cm, then it stops,
my fan doesn,t work on any of the speeds, do you think its the switch and how do i get it out,,, and just one thing,, where can i get a new one!!
thanks,
bernie the newbie,
Posted: Mon Jun 04, 2007 11:07 pm
by pippin
Stop struggling with the dash - it isn't the switches.
The fault will be the fan resistor assembly under the bonnet.
Do a search as there is already masses of info on this already on the forum, plus a detailed fact sheet in the (£10 subscription and a bargain at that) Members Club.
Posted: Wed Jun 06, 2007 6:42 pm
by berniehoo
pippin wrote:Stop struggling with the dash - it isn't the switches.
The fault will be the fan resistor assembly under the bonnet.
Do a search as there is already masses of info on this already on the forum, plus a detailed fact sheet in the (£10 subscription and a bargain at that) Members Club.
i did what you said, i bought a fan resistor and just fitted it!!!! £50!!!! and no change!!! so back to my first question, how do i get the fan switch out of the dash? please can somebody help me!
Posted: Wed Jun 06, 2007 7:01 pm
by pippin
Oooooooops!!!
There are a couple of Bowden cables coming out from the unit, one of which disappears towards the drivers left leg.
Undo the clip which holds it and you should find the assembly will come further forwards.
Posted: Wed Jun 06, 2007 10:52 pm
by Lewy
I'd check to see if the fan motor spins - if you take off the plastic air intake you can get your hand in - see if it turns easily - could be seized which most people think causes the resistor to blow its solder contacts.