Page 2 of 2
Re: Air Con Tensioner pulley
Posted: Sun Jun 04, 2017 9:13 pm
by windywatson
I'm sure the kit I fitted to run blinds, radio etc from my LB was a Wilton kit. It was well made & not to expensive.
And thanks Geoff for the information on what addition equip is feed from the fuses used swapped over to LB. This would explain the slightly higher current draw than I expected.
cheers
Re: Air Con Tensioner pulley
Posted: Sun Apr 21, 2019 1:50 pm
by Tymmuffphii
Could someone possibly post a diagram is this setup to me please? I have the same issue, and when iv finished what I thought to be correct, iv tightened it up now the pulley doesn't spin freely on its bearing as it should......
Won't it come undone if I loosen it ??????
Need help asap
[email protected]
Re: Air Con Tensioner pulley
Posted: Wed May 08, 2019 5:59 pm
by windywatson
Sorry for late response, how did you get on with your problem? With the type of bearing fitted to this pully, if it is stiffening up the pully when tightened then the bearing must be faulty. It shouldn't cause it to stiffen up at all.
Re: Air Con Tensioner pulley
Posted: Wed May 08, 2019 7:00 pm
by teenmal
This if from earlier on in this post...…..
Re: Air Con Tensioner pulley
Quote
Post
by rita » Thu Jun 01, 2017 9:50 am
Presuming we are talking about vehicle with Diesel Engine.
Yes its nut/pulley/washer (dust cover) then spacer against sliding bracket.