Bongo Fury

Does look like two parts to the wing going by the lushproject picture.Could do with some one who`s taken one off to confirm
it like you say.Cheers for that,much appreciated.

the wing is 1 part not 2 parts

to take off open front door (bolts on inside ) 3 i think
under bonnet on top of wing
i cant remember if bumper has to be undone

hope this helps

ps contact japcarinports (ian taylor) in market drayton he will do the job for you

Front wings are relatively easy to change, so my advice would be to find a replacement wing from a Bongo that is being broken. I know this is a passenger side wing, but £46 is good value compared to get the existing one repaired & sprayed:

http://cgi.ebay.co.uk/MAZDA-BONGO-NEAR- ... 20ada81df7

Give Bellhill a call & see if they can get you a drivers side wing to match.

eckerB wrote:That rusty seam is not part of a weld then?So if the wing was unbolted it comes in two parts
at this point where the rust is.

Nope.

It does for some reason look like its a seperate panel at the bottom end but not the case, its all part of the wing.

As already said though, a pretty cheap fix - short term.

The wing is an offside wing,anyone know of one for sale?Will give Bell Hill garage a ring too.
Thanks everyone for you help,appreciated.Eric.

i've just had 2 complete rear arches fitted and a full respray (the rust damage was much worse than your photo!)
the guy that did is not a million miles away from you and a well respected Bongo man, sales,mechanics and bodywork.
Ian Taylor, Market Drayton.
highly reccomend his work, if it's good sound advice your after, he's the man.

Bongonaught - roughly how much did that cost you? I need the same, well for me it's the inner and outer wheelarch panels rusted.